Windows Xp - Icom IC-7200 Installation Manual

DRIVER INSTALLATION (Continued)

Windows XP

NOTE:
BE SURE to connect the transceiver to the PC with the USB cable (third party) before installing the USB
driver.
The displayed dialogue boxes, indications or oper-
ations may differ slightly from the following instruc-
tions according to your system conditions or envi-
ronment.
q Make sure that the transceiver is not connected to
the PC.
w Start up Windows.
• Quit all other application if running.
e Connect the transceiver to the PC with the USB
cable (third party) as shown below.
• Be sure to connect the USB cable correctly and not up-
side down.
To USB jack
Type B
USB cable
(third party)
Type A
To USB port
r Turn the transceiver power ON.
• "Found New Hardware" appears as below.
REMOTE
KEY SEND ALC
ACC
Transceiver
PC
t T he "Welcome to the Found New Hardware Wizard"
will come up as below.
Select "No, not this time," then click [Next>].
Select
y S elect "Install from a list or specific location
(Advanced)," then click [Next>].
Select
u S elect "Search for the best driver in these locations."
then select "Include this location in the search," and
click [Browse].
Select
Select
6
Click
Click
Click
☞ Continues to the next page