Controls button button (Eject) (Amsterdam 130 only) Eject a CD Unlock the detachable control panel USB socket MENU button Short press: Call up/close menu Front AUX-IN socket Long press: Start scan function Keys 1 - 6 On/Off button < Infrared receiver...
• Do not modify or open the device. The device DANGER! contains a Class 1 laser that can cause injuries to your eyes (Amsterdam 130 only). Warns about injuries • Do not increase the volume during mute phases, e. g. when changing the audio source.
Declaration of conformity Optional equipment (not part of the scope of delivery) The Blaupunkt Europe GmbH declares that the car sound system complies with the basic require- Use only accessories approved by Blaupunkt. ments and the other relevant regulations of the Information is available from your Blaupunkt directive 2004/108/EC.
Placing the device in operation Always take the control panel with you when leav- The car sound system switches off . ing the vehicle. The car sound system is worthless Note: to a thief without this control panel. If you switch on the car sound system while the vehicle ignition is switched off , it auto- Caution matically switches off after 1 hour to preserve...
Placing the device in operation | Traffi c information | Radio mode • The display brightness can be adjusted Radio mode separately for day and night (see the chap- ter "User settings", section "Making set- tings in the "DISPLAY" menu", menu items Many FM stations broadcast an RDS (Radio Data "DIM DAY"...
Radio mode Tuning into a station Scanning stations There are various ways of tuning into a station: With the scan function, you can scan either every receivable station or the stored stations of the cur- Tuning into stations manually rent waveband. u Briefl y press the button once or...
Radio mode The tuner starts the automatic station seek Searching for stations u Press the tuning; the display shows "FM TSTORE" or button "AM TSTORE". After the storing is completed, During the seek tuning, the currently selected the radio plays the station at memory location programme type is shown on the display.
This car sound system can be used to play MP3 or WMA fi les on USB data carriers and SD(HC)/MMC • "CD" (Amsterdam 130 only): Inserted CD memory cards. • "SD(HC)" (Adelaide 130 only): Inserted...
CD/MP3/WMA mode Note: • The time required for reading in the data depends on the design and size of the USB You must not hinder or assist the drive as it data carrier. automatically draws in the CD. u Insert the CD with its printed side up into the Removing a USB data carrier CD tray until you feel a slight resistance.
Gen. RPT OFF Regular playback playback ("PAUSE") or to continue it. * Amsterdam 130 only Scanning all tracks If the RPT function is switched on, the icon (repeat tracks) or (repeat The scan function scans all available tracks.
CD/MP3/WMA mode | External audio sources Fast browsing Browse mode Fast browsing enables faster access to tracks. In- In Browse mode, you can directly search for and stead of the arrow keys , you use the volume select a certain track on the MP3/WMA data carrier control and the On/Off button to select...
Sound settings Sound settings Making settings in the "AUDIO" menu The following sound settings can be changed in the "AUDIO" menu: BASS • Adjusting bass and treble Bass level. Settings: –7 to +7. • Setting the left/right volume distribution u Press the On/Off button to change the (Balance) or front/rear (Fader) setting.
Sound settings | User settings PRESETS Notes: Selecting equalizer presettings. Settings: POP, • The menu is automatically exited approx. ROCK, CLASSIC, EQ OFF. 16 seconds after the last button activation and you are returned to the display of the u Press the On/Off button to change the current audio source.
User settings REGIONAL PTY TYPE (only for reception area EUROPE) Only possible with activated PTY function: Select Only possible in FM radio mode: Switching a programme type. REGIONAL function on or off . Settings: ON, OFF. u Press the On/Off button to change the u Press the On/Off button to change the...
User settings u Turn the volume control to change be- LAST VOL tween the settings. If you select the setting LAST VOL, every time you switch on the radio, the volume level that was set Automatic switching of the display brightness is the last time you switched the radio off is activated possible only If your car sound system is installed again.
User settings RDS CLOCK (automatic time setting) Making settings in the "CLOCK" (only for reception area EUROPE) menu Switching automatic clock setting with clock data CLK DISP transmitted via RDS on or off . Settings: ON, OFF. Switch the permanent display of the time on or off . Note: Settings: ON, OFF.
User settings | Factory settings SWC (Steering Wheel Control confi guration) Factory settings Confi guring the buttons of a connected steering Important factory settings in the user menu: wheel control. u Press the On/Off button Menu item Factory setting to open the menu.
The warranty terms can be called up from www.blaupunkt.com. Pre-amp out 2 channels: Service In some countries, Blaupunkt off ers a repair and Input sensitivity pick-up service. Front AUX-IN: 300 mV / 10 kΩ Information about the availability of this service in Dimensions and weight your country can be found at www.blaupunkt.com.
• Do not connect the vehicle’s plug connec- tors to the radio! You can obtain the adapter cable required for your vehicle type from any BLAUPUNKT dealer. • Depending on the model, your vehicle may diff er from the description provided here. We...
Page 22
Installation instructions Supplied mounting hardware Available as an optional accessory 7 607 621 … Installation kits 7 608 … …...
Page 23
Installation instructions Steering wheel remote control SWC-2 SWC-1 Antenna connection 1 2 V 2. Amsterdam 130 only Antenna Preamp out (2 channels) 1-20 0° - 30° +/– 10° +/– 10°...
Page 25
Installation instructions Speaker out RR+ Telephone Mute Speaker out RR– Speaker out RF+ Permanent +12V Speaker out RF– Auto antenna* Speaker out LF+ Illumination Speaker out LF– Kl.15/Ignition Speaker out LR+ Ground Speaker out LR– Switched power supply +12 V / max. 150 mA...