Product Literature - HUSTLER Z4 Owner's Manual

When storing the unit at the end of the mowing season, the
following steps should be taken to ensure readiness for the next
mowing season.
1. Remove all grass, dirt, and trash from tractor and cutting
units.
IMPORTANT: Wash the machine with a mild detergent
and water. Do not pressure wash the machine. Avoid
excessive use of water
Clean tractor and mower and touch up all scrapes with
touch-up paint.
2. Replace air filter element.
3. Check thoroughly for any worn or damaged parts that
need replacing and order them from your dealer.
4. Block tractor up so weight is off tires. Check tire pressure
and inflate to proper operating pressure.
NOTE: Do not deflate tires.
5. Perform separate engine and battery preparation as listed
below.
6. Store tractor in a clean, dry place.
Preparation of engine for storage
When engine is to be unused for long periods, proceed as
follows:
1. Run engine for a minimum of 15 minutes.
2. Drain oil from crankcase while engine is still warm.
3. Refill with fresh oil of proper viscosity.
4. Drain fuel tanks.
5. Remove and replace fuel filter.
6. Clean exterior surface of engine. Spread a light film of
oil over any exposed metal surfaces of engine that are
subject to corrosion.
7. Check oil filler cap and fuel tank cap to make certain they
are securely in place.
If you would like to view or print a copy of the Hustler Z4 product manuals go online to www.hustlerturf.com and click on the
MANUALS button.
STORAGE
Preparation of battery for storage
When the machine is to be unused for long periods, it is best
to disconnect the batteries and remove them from the unit. At
this time perform the following battery maintenance:
1. Remove the battery from machine
2. Clean battery, terminals and cable connectors
3. Charge the battery, if necessary
4. Store battery in a cool, dry place (do not expose to
5. Always keep the battery fully charged.
New season preparation
Before starting the tractor following post season storage, the
following servicing is required:
1. Clean tractor, removing trash and dirt accumulation.
2. Check engine oil, hydraulic oil and coolant levels.
3. Fill fuel tanks with fresh fuel. Bleed fuel system as
4. Tighten any bolts that have loosened and make sure all
5. Install all safety shields and review safety precautions
6. Check and inflate tires to 8-12 psi (55-83 kpa).
7. Install fully charged batteries and attach the battery

PRODUCT LITERATURE

5-2
freezing temperatures)
important to prevent battery damage when the
o
temperature is below 32 F.)
outlined in Maintenance section. Run machine at half
speed for 5 minutes, checking operation of steering
control lever. Stop engine and check for oil leaks, loose
fittings and so forth.
WARNING: At start of new season always check that
fresh oil and coolant have been added to machine. If
oil and coolant are drained at season's end and not
replaced, engine damage will result.
hair pins, cotter pins and clevis pins are in place.
listed in this manual.
cables.
(Especially
602223_0609