If the machine’s forward motion must be stopped while
mowing, a clump of grass clippings may drop onto your lawn.
To avoid this, move onto a previously cut area with the blades
engaged.
WARNING: Never direct discharge of material from
mower deck towards bystanders. Do not operate the
mower without either the discharge chute or the entire
grass collection system in place. Figure 3-10
Discharge
chute
Figure 3-10
Mower deck operation
DANGER: Never attempt to make any adjustments to
the mower deck while the engine is running or with
the deck drive clutch engaged. Mower blades cannot
be seen and are located very close to deck housing.
Fingers and toes can be cut off instantly.
With the engine running, engage the deck clutch switch
(Figure 3-1) and advance engine throttle to full rpm.
NOTE: Engaging the deck clutch at high engine rpm or
when under heavy load (in tall grass for example) can cause
belts and/or electric clutch to slip, resulting in premature wear or
possible damage.
Deck cutting height adjustment
Deck height is adjustable from 1-1/2” to 4-1/2” (3.81 cm -
11.43 cm) in 1/4” (.64 cm) increments. The holes in the height
adjusting bar are spaced at 1/2” (1.27 cm) intervals. By turning
the height adjusting stop around, 1/4” (.64 cm) increments can
be attained due to the 1/4” (.64 cm) plate that is part of the stop.
Figure 3-11
EXAMPLE: When the height adjusting stop is placed in the
1-1/2” (3.81 cm) hole, with the 1/4” (.64 cm) plate facing to
the front of the unit, the cutting height is at 1-1/2”. When the
height adjusting stop is placed in the 1-1/2” (3.81 cm) hole,
with the 1/4” (.64 cm) plate on the operator’s side of the
hole, the cutting height is at 1-3/4” (4.45 cm).