Table of Contents
Advertisement
Other User Detected Errors
The following issues may be detected by the user but may not reported by the printer to the Feature Management
Mode.
Description of Issue
No power or
LEDs are not on
Media not feeding
properly
Media is drifting to
the right as it comes
out of the printer.
Fastmark 600 Series User's Guide
Possible Problem
Printer not attached to a
power source.
Power Switch is not in the
on position.
Is the printer in FeatureMan
mode?
Media Latches not closed.
Media not installed
correctly
Media Guides not in the
proper position.
Possible Correcting Procedures
1.
Verify Power Plug on back of printer is pushed firmly
in.
2.
Verify Power Adapter is connected to a known power
source.
3.
See Maintenance Manual for procedure of verifying
and changing of the fuse.
1.
Verify Switch is in the '1' position.
2.
Toggle switch to verify both off and on condition.
1.
Press the PAUSE key to see if the Ready LED comes
on.
2.
Cycle Power on the printer.
3.
Replace the printer.
1.
Open the Top Cover.
2.
Verify Media is installed according to the Loading
Instructions.
3.
Press firmly on the top of the Printhead Mechanism
and verify the both the right and left latches are locked.
4.
Close the Top Cover.
Verify Media is installed according to the Loading
Instructions.
1.
Open the Top Cover.
2.
Verify Media is installed according to the Loading
Instructions.
3.
Verify that the right Media is in the proper Position.
The media needs to be snug between the left and right
guides.
73
Advertisement
Table of Contents
