Figure 34 – Changing Features; Figure 35 – Changing Feature Values - AMT Datasouth Fastmark 600 Series User Manual

7. Click the Display Up/Down buttons to enter the setup mode.
8. Continue to click the Display Up/Down buttons as needed until the feature to be modified
is displayed on the top line of the display. (ex. Baud Rate)
9. Click the Enter button to enter the Change mode. The top line of the display should start
blinking to indicate the Change mode is active.
10. Click the Display Up/Down buttons as needed to select the new value.
11. Click the Enter button to save the new value and exit the Change mode. The top line of
the display should no longer be blinking.
12. When all features have been adjusted, click the Online/Offline button and the printer is
now ready for use. If a PAL program is loaded, the message now displayed on the
simulated printer LCD will vary depending on the program.
Fastmark 600 Series User's Guide
Figure 34 – Changing Features
Figure 35 – Changing Feature Values
37