Unpacking And Inspection; Figure 4 – Shipped With Printer - AMT Datasouth Fastmark 600 Series User Manual

UNPACKING AND INSPECTION

This section is provided to assist you in removing the printer from the shipping container and
setting it up in the application environment. Inspect the shipping carton and contact the carrier
directly to report any suspected damage.
1. With the shipping container in the upright position, remove the top foam packing piece.
2. Carefully, lift the printer straight up out of the box.
3. Remove the printer from the plastic bag and place the printer on a flat stable surface.
4. Remove the accessory kit and supplies.
5. Inspect the shipping container and the printer for any damage that may have occurred
during shipping.
Note: Save the box and all packing materials for future use, in the event the
printer needs to be shipped.
approved packaging may void the warranty or increase repair costs
due to shipping damage.
Verify that the printer box contains the following materials when unpacking:
a. Printer
b. 3 inch Media spindle adapter
c. AC Power Cord
d. RS-232 Serial Cable (not shown in below figure)
e. CD that contains User's manual and Windows drivers
f. A sample media roll
g. A sample ribbon roll and a take-up ribbon core
h. Two Ribbon Core adapters for ribbon cores that are smaller than 4.325 inches in width.
Printer
Power Cord
Fastmark 600 Series User's Guide
Units returned for service in non-
Sample Media
Figure 4 – Shipped with Printer
Sample Ribbon
3" Media Adapter
Ribbon Core Adapter
CD
14