Air Filter - Husqvarna K650 Operator's Manual

Husqvarna cut-n-break operator's manual
Hide thumbs Also See for K650:
Table of Contents

Advertisement

Air filter
Air filters must be regularly cleaned to remove dust and dirt in
order to avoid:
Carburettor malfunctions
Starting problems
Less power
Unnecessary wear to engine parts
Excessive fuel consumption.
The air filter system consists of an oiled foam plastic filter (1)
and a paper filter (2):
The foam plastic filter is easily accessible under the filter
cover A. This filter should be checked weekly and
replaced if necessary. In order to obtain a good filtering
effect, the filter must be replaced regularly or cleaned and
oiled. A special HUSQVARNA oil has been produced for
this purpose.
Remove the foam plastic filter. Wash the filter well in tepid
soapy water. After cleaning, rinse the filter well in clean
water. Squeeze out and allow the filter to dry. NOTE! High
pressure compressed air can damage the foam.
Oil the foam plastic filter well. It is extremely important that
the entire filter is saturated with oil.
Put the filter in a plastic bag and pour the filter oil over it.
Knead the plastic bag to distribute the oil. Squeeze the
excess oil out of the filter inside the plastic bag and pour
18 –
English
MAINTENANCE
off the excess before fitting the filter to the machine. Never
use common engine oil. This would drain through the filter
quite quickly and collect in the bottom.
A foam plastic filter that has been washed many times
wears. Replace with a new filter if it is not elastic and seals
well against the filter cover.
The paper filter is accessible under cover B. This filter
must be replaced/cleaned when the engine's power drops
or after one-two weeks. Note that the filter must not be
washed.
An air filter that has been in use for a long time cannot be
cleaned completely. The filter must therefore be replaced with
a new one at regular intervals. A damaged air filter must
always be replaced.
IMPORTANT! Poor maintenance of the air filter will cause
carbon build-up on the spark plug and abnormal wear to
engine parts.
Fuel filter
The fuel filter sits inside the fuel tank.
The fuel tank must be protected from contamination when
filling. This reduces the risk of operating disturbances
caused by blockage of the fuel filter located inside the
tank.
The filter cannot be cleaned but must be replaced with a
new filter when it is clogged. The filter should be
changed at least once per year.
Water tap
Water filter
Check and clean the restrictor if necessary.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

K650 cut-n-break

Table of Contents