Sign in today to find solutions:

Don't have an account? Sign up

Husqvarna LT130 Owner's Manual [Page 7]: Seat

Husqvarna lawn tractor owner's manual.

   
CONNECT BATTERY (See Figs. 2 and 3)
CAUTION: Do not short battery termi-
nals. Before connecting battery, re-
move metal bracelets, wristwatch
bands, rings, etc.
Positive terminal must be connected
first to prevent sparking from acciden-
tal grounding.
Remove cardboard packing from seat pan and lift seat
pan to raised position.
Open battery box door.
Remove terminal protective caps and discard.
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
First connect RED battery cable to positive (+) terminal
with hex bolt, flat washer, lock washer and hex nut as
shown. Tighten securely.
Connect BLACK grounding cable to negative (-) termi-
nal with remaining hex bolt, flat washer, lock washer
and hex nut. Tighten securely.
Close battery box door.
Open battery box door for:
Inspection for secure connections (to tighten hard-
ware).
Inspection for corrosion.
Testing battery.
Jumping (if required).
Periodic charging .
DISCARD
TERMINAL
POSITIVE
PROTECTIVE
(RED) CABLE
CAPS
ASSEMBLY
LOCK
HEX
WASHER
NUT
FLAT
WASHER
NEGATIVE
(BLACK) CABLE
FIG. 2

SEAT

PAN
BATTERY
BOX DOOR
INSTALL SEAT (See Fig. 4)
Adjust seat before tightening adjustment knob.
Remove cardboard packing on seat pan.
Place seat on seat pan and assemble shoulder bolt.
Assemble adjustment knob and flat washer loosely.
Do not tighten.
Tighten shoulder bolt securely.
Lower seat into operating position and sit on seat.
Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal all the way
down.
Get off seat without moving its adjusted position.
Raise seat and tighten adjustment knob securely.
SHOULDER
BOLT
HEX
BOLT
ADJUSTMENT
BOLT
7
FIG. 3
SEAT
SEAT PAN
LARGE FLAT WASHER
FIG. 4
Next page -> <- Previous page

Comments to this Manuals

Symbols: 0

Latest comments:

×

Select the desired size and copy embed code

Copy your embed code and put on your site: