Repair instructions
2
Fit the carburettor. Screw in the carburettor bolts
directly from behind, without lifting the carburettor
assembly. Tighten to a torque of 1–1.5 Nm. It is
important to hold the carburettor flange while
tightening the bolts to prevent the inlet manifold
from moving.
3
Push the rear carburettor mounting into its rubber
bushing using a small screwdriver. Remove stop
plate 502 54 17-01.
4
Connect the fuel hose to the carburettor. Refit the
throttle pushrod at the same time as the rubber
inlet manifold, press in the throttle pushrod so that
it engages in the carburettor and fit the spring.
34
– English
5
Connect the leads to the stop switch.
Carburettor heater 346XP, 351, 353 –
Refitting
1
Fit the heating element between the air filter
connection and the carburettor as well as above
the carburettor.
2
Tighten the bracket above the carburettor using the
two bolts.
3
Connect the leads to the carburettor heater.
Refit:
• carburettor
Heating element