Husqvarna 340 Workshop Manual page 20

Husqvarna gas chain saw workshop manual
Hide thumbs Also See for 340:
Table of Contents

Advertisement

6
Unscrew the two bolts from the right side of the
rear hand grip. Remove the throttle lock and
throttle handle, see "Throttle trigger". Pull out the
heater element with the leads still connected.
Troubleshooting carburettor heater
(346XPG, 351G, 353G)
Operation
The carburettor temperature is controlled by an
electronic thermostat to eliminate the risk of ice
formation in the carburettor. The thermostat
switches on/off at 12°C/54F. This means that the
saw operator does not need to remember to switch
the carburettor heater on or off.
• Troubleshooting
Front handle heater
Remove the side cover from the handle. Discon-
nect the leads at F and G (see diagram).
Clean the connectors. Turn the switch "on".
Measure the resistance between F and G.
The reading should be 4±1 ohms. If not, discon-
nect the lead at O and remove the switch.
Measure the resistance between O and F. The
reading should be 4±1 ohms. If the resistance is
incorrect, replace the front handle.
Disconnect the lead at N and G and measure the
resistance between these points. The reading
should be no higher than 0.1 ohm. If it is too high,
replace the lead.
Switch
Measure the resistance between N and O with the
switch turned off. The reading should be 1 000
ohms or higher.
Repeat the measurement with the switch turned
on. The reading should be no higher than 0.1 ohm.
If it is too high, replace the switch.
Rear handle heater
Measure the resistance between F and Z. It should
be 1 ± 0.5 ohm.
If not, replace the rear handle heater.
Generator
Measure the resistance between G and H. It
should be between 0.3–1.3 ohm.
If not, replace the generator.
Carburettor heater
Disconnect the lead at X and clean the connectors.
Measure the resistance between X and G.
The reading should be between 3–10 ohms. If not,
disconnect the lead at Y and clean the connectors.
Measure the resistance between X and Y, if the
reading is not between 3–7 ohms – replace the
carburettor heater.
O
O
N
N
F
F
G
G
K
K
V
V
Repair instructions
Z
Z
5
5
3
3
X
X
4
4
1
1
Y
Y
H
H
English –
19

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

340, 345, 346xp,350, 351, 353345346xp350351353

Table of Contents