1. Manuals
  2. Brands
  3. Hunter Manuals
  4. Thermostat
  5. Set & Save 47250A
  6. Owner's manual

Hunter Set & Save 47250A Owner's Manual

Hunter owners manual programmable thermostat 47250a
Hide thumbs
Table of Contents

Advertisement

Quick Links

®

Programmable Thermostat

Owners Manual
Model 47250A

Advertisement

Table of Contents
loading

Related Manuals for Hunter Set & Save 47250A

Summary of Contents for Hunter Set & Save 47250A

  • Page 1: Programmable Thermostat

    ® Programmable Thermostat Owners Manual Model 47250A...

  • Page 2: Installation

    (95˚F), and automatically cut-off in Cool mode if the temperature drops below 4˚C (40˚F). 3. Compressor Protection This thermostat provides a 3.5 minute delay after shutting off the cooling system before it can be restarted. This feature will prevent damage to your compressor caused by rapid cycling. It does not prevent a rapid compressor restart due to short power outages.

  • Page 3: Wire Labeling

    If hole in wall is larger than necessary for wires, seal this hole with insulating material so that no hot or cold air can enter the back of the thermostat from the wall. This air could cause a false thermostat reading.

  • Page 4: Operation

    Fan come on as expected after installation. If the Fan operation is normal, leave it in the “HG” position. If the Fan does not come on within a minute of the thermostat calling for heat, change the switch position to “HE”. The system selector has no effect in the cooling mode.

  • Page 5: Programming

    12 Hr. / 24 Hr. Time Format Your thermostat is set from the factory in normal 12 (AM / PM) time format. To change to 24 hour (military) time, press program at any time while the Hour, Minute, or Day is flashing to toggle between the 12 hour and 24 hour formats.

  • Page 6: System Selector/Fan Switch

    SPAN Setting Mode Your thermostat is set at the factory to cycle at 0.5˚C (1˚F) above and below the set temperature. (Span = 2) This setting has been designed to provide a comfortable room temperature under most all conditions. However, if you find your system cycling too fast or too slow, then the Span can be adjusted to modify the cycle time.

  • Page 7: Error Mode

    Auto Cut Off Your thermostat will automatically cut-off in Heat mode if the room temperature rises above 35˚C (95˚F). It will cut-off in Cool mode if the room temperature drops below 4˚C (40˚F). Note that if your system has malfunctioned and no longer responds to thermostat controls, the Auto Cut-Off will have no effect.

Table of Contents