Important Information; Installation Procedures - Hunter 144860 Installation And Operation Manual

IMPORTANT INFORMATION

This thermostat is designed to work on the following heating and cooling systems:
Up to 2 Stage Heat/2 Stage Cool
Heat Only or Cool Only Systems
Single and Multi-Stage Heat Pumps
Gas, Electric or Oil Systems
This thermostat is not designed for use with 110V/220 V systems. If you are unsure of
what kind of heating and cooling system you have, please contact a qualified HVAC
Technician for assistance.

INSTALLATION PROCEDURES

TOOLS
This thermostat includes two #8 slotted screws and two wall anchors for mounting.
To install your new thermostat, you will need the following supplies:
Flat-head screwdriver, Small Phillips-head screwdriver, Hammer
Electric drill and 3/16" bit, Three 1.5 Volt (AA) size alkaline batteries

Millivolt Systems
2-wire Hydronic Systems
AC or Hard-wired
44002-01 r051807