OWNER'S MANUAL WD12570FD WD12576FD Thank you for buying a LG Fully Automatic Washing machine. Please read your owner's manual carefully, it provides instructions on safe installation, use and maintenance. Retain it for future reference. Record the model and serial numbers of your washing...
roduct Feature Direct Drive System The advanced Brushless DC motor directly drives the drum without belt and pulley. Water Circulation Sprays detergent solution and water onto the load over and over. Clothes are soaked more quickly and thoroughly during wash cycle. The detergent suds can be removed more easily by the water shower during rinse cycle.
arnings READ ALL INSTRUCTIONS BEFORE USE For your safety, the information in this manual must be followed to minimize WARNING! the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life. IMPORTANT SAFETY INSTRUCTIONS WARNING : To reduce the risk of fire, electric shock, or injury to persons when using the washer, follow basic precautions, including the following: •...
Page 4
arnings To minimize the risk of fire in a tumble dryer, the following should be observed: • Items that have been spotted or soaked with vegetable or cooking oil constitute a fire hazard and should not be placed in a tumble dryer. Oil-affected items can ignite spontaneously, especially when exposed to heat sources Such as in a tumble dryer.
nstallation Install or store where it will not be exposed to temperatures below freezing or exposed to the weather. Properly ground washer to conform with all governing codes and ordinances. The base opening must not be obstructed by carpeting when the washing machine is installed on a carpeted floor.
nstallation Installation place requirement Level floor : Drain Hose Allowable slope under entire washer is 1° Washer Power outlet : Must be within 1.5 meters of either side of location of washer. Do not overload the outlet with more than one appliance.
nstallation Electrical connection 1. Do not use an extension cord or double adapter. 2. If the supply cord is damaged, it must be replaced by the manufacturer or its service agents or similarly qualified person in order to avoid a hazard. 3.
nstallation Normal Tap without thread & screw type inlet hose Unscrew the fixing screw to Push the connector up till the Push the water supply hose attach the tap. rubber packing is in tight contact vertically upwards so that the with the tap.
Page 10
nstallation This equipment is not designed for maritime use or for use in mobile installations such as caravans, aircraft etc. Turn off the tap if the machine is to be left for any length of time (e.g. holiday), especially if there is no floor drain(gully) in the immediate vicinity.
• If possible install the washer in one of the corners of the room, where the floor is more stable. Insert the rubber cups to reduce vibration. Rubber cups ( p/no. 4620ER4002B ) can be purchased from the LG spare parts department. Important! •...
are before washing Before the first washing Select a cycle (COTTON 60°C, add a half load of detergent) allow the unit to wash without clothing. This will remove residues from the drum that may have been left during manufacturing. Caring before washing 1.
dding detergent Adding detergent and fabric softener 1. The Dispenser Drawer 3. Detergent dosage • The detergent should be used according to the instruction of the detergent manufacture. • If too much detergent is used, too many suds can occur and this will decrease the washing result or cause heavy load to the motor.
unction Recommended courses according to the laundry type Proper Temp. Additional Maximum Program Fabric Type (Option) Option Load Color fast garments 60˚C (Cold, (shirts, night dresses, Cotton Pre Wash Rating 30˚C, 40˚C, pajamas...)and lightly soiled Rinse+Spin 95˚C) white cotton (underwear...) Dry Only Less Steam Polyamide, Acrylic,...
ow to use washer 2. Manual Selecting 1. Cotton automatically selected upon power on. • Press the Power( ) button to turn the washer on. • Press the Power( ) button to start. • Select the desired cycle with the •...
Page 16
ow to use washer (6) (7) (8, 9, 10) (11) (12) (13) (1)Button: Power (5)Child lock (9)Button: Tub Clean (13)Dial: Dry (2)Dial: Program (6)Button: Rinse (10)Button: Time Delay (3)Button: Start/Pause (7)Button: Temperature (11)Button: Spin (4)Button: Option (8)Button: Intensive (12)Button: Turbo Steam Power Program 1.
ow to use washer Start/Pause Option • By pressing the option button, only one option functions may be selected. 1. Start NOTE: Depending on the selected • This Start/Pause button is used to start program cycle, not all wash cycle or pause the wash cycle. Options may be selectable.
ow to use washer Child lock Rinse • By pressing the Rinse button, the Rinse type can be selected. - Normal If you choose to lock the buttons on the - Rinse + control assembly to prevent tampering, this - Medic Rinse function may be selected.
ow to use washer Spin Water Temperature • By pressing the Spin button, • By pressing the Temp. the spin speed can be button, the water chosen. temperature can be selected. - Cold - 30˚C / 40˚C / 60˚C / 95˚C •...
ow to use washer Tub Clean Time Delay Tub Clean course can be set by pressing ‘Tub Clean’ button. TUB CLEAN is special cycle to clean the inside of the washer. This cycle uses higher Preparing washing before starting “Time Delay” water level with higher spin speed.
Page 21
ow to use washer Intensive Refresh I Refresh cycle • For slightly wrinkled clothes which have been stored for an extended time. It just makes wrinkled clothes easy to iron (Do not load wet clothes). • When washing full load or heavily soiled laundry, you can increase effectiveness by •...
Page 22
ow to use washer NOTE 1.Drying Automatic guide The maximum drying capacity for this model is 6kg. When loading, please • Use your Automatic Cycles to dry most loads. use the maximum drying capacity Electronic sensors measures the temperature indicator behind the door as shown of the exhaust to increase or decrease drying below.
ow to use washer 2.Drying time guide 3.Completion of Drying • By turning the Dry button, the drying time • When drying cycle is completed, “ ” [Cool can be selected. Down] is displayed on the Multi display. • Drying course can last up to 150min. When •...
Page 24
ow to use washer Display 3. Completion of washing • When washing cycle is completed, “ ” is displayed on the “Multi display”. 1. Special function display 4. Time left • When Child lock is selected, the • During washing cycle, the remaining “...
aintenance ❋ Before cleaning the washer interior, unplug the electrical power cord to avoid electrical shock to avoid electrical shock hazards. ❋ When disposing of the appliance, cut off the mains cable, and destroy the plug Disable the door lock to prevent young children being trapped inside. The water inlet filter - "...
aintenance Dispenser drawer ❋ After a while detergents and fabric softeners leave a deposit in the drawer. • It should be cleaned from time to time with a jet of running water. • If necessary it can be removed completely from the machine by pressing the catch downward and by pulling it out.
Page 27
aintenance The water circulation nozzle & steam nozzle • Clean the water circulation nozzle, if clogged. Cleaning your washer 1. Exterior Proper care of your washer can extend its life. The outside of the machine can be cleaned with warm water and a neutral non abrasive household detergent.
roubleshooting guide ❋ This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately. When the machine does not function properly or does not function at all, check the following points before you contact your service provider. Symptom Possible Cause Solution...
Page 29
roubleshooting guide Symptom Possible Cause Solution Water in the washer • Drain hose is kinked or Clean and straighten the drain hose. does not drain or clogged. drains slowly. • The drain filter is clogged. Clean the drain filter. Washer does not •...
Page 30
roubleshooting guide Symptom Possible Cause Solution • It takes time to balance the Wash cycle time The washing time may vary by the laundry before the spin cycle delayed amount of laundry, water pressure, water temperature and other usage conditions. If the imbalance is detected or if the suds removing program works, the wash time shall be increased.
Page 31
roubleshooting guide Symptom Possible Cause Solution Check another tap in the house. • Water supply is not adequate in area Fully open tap. • Water supply taps are not completely open. Straighten hose(s). • Water inlet hose(s) are kinked. Check the filter of the inlet hose(s). •...
erms of Warranty What Is Not Covered: • Service trips to your home to teach you how to use the product. • If the product is connected to any voltage other than that shown on the rating plate. • If the fault is caused by accident, neglect, misuse or Act of God. •...