Drain Pump - GE Mabe GLD9312 Technical Service Manual

Mabe built-in dishwasher with stainless steel tall tub
Hide thumbs Also See for Mabe GLD9312:
Table of Contents

Advertisement

Wash Pump Disassembly con't
5. Remove 2 screws holding the fine filter
assembly and lift to remove.
6. Remove the 1 screw holding the coarse filter.
Lift out the coarse filter.
7. Remove the 2 screws holding the inlet
protector.
Wash Motor
1. Disassemble the wash pump (see procedure)
2. Remove the press on nut to disassemble the
pulveriser
2 screws
3. Remove the pulveriser blade, screen, spring and
4. Tip dishwasher on its back. Remove the one
Screw
5. Disconnect the motor connector and rotate the
2 Screws
Note: Before removing the wash motor, remove the
water from the sump with a syringe

Drain Pump

1. Disconnect the pump connector
2. Press the tab and rotate the pump assembly
13
washers.
Order of pulveriser components
Philips head screw that holds the motor in
place. It is located behind the cardboard shield.
motor clockwise until it disengages from the
sump.
counter clockwise to remove.
Press on
Nut
Philips head
screw

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Mabe GLD9312 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Mabe gld8312Mabe gld8110

Table of Contents