Advertisement
Quick Links
Remote Mobile Security System
OWNER'S
MANUAL
Model: PL61
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference; and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications
to this equipment. Such modifications could void the user's authority to operate the equipment.
Advertisement
Related Manuals for Magnadyne PL61
Summary of Contents for Magnadyne PL61
- Page 1 Remote Mobile Security System OWNER’S MANUAL Model: PL61 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference; and (2) This device must accept any interference received, including interference that may cause undesired operation.
- Page 2 The information enclosed will provide a ready reference of the operation and maintenance of your new security system. The operating instructions enclosed are for two security system models. Many of the functions are similar between the models but be sure to follow the instructions that pertain to your model security system only.
- Page 3 Automatic Arming (Without Using the Transmitter) Note: The following information is valid only if your security system has been programmed to automatically arm. 1. Turn off the ignition key and exit the vehicle. 2. Close all protected entrances. After the last protected entrance is closed the horn/siren will chirp one time and the LED indicator will begin to flash fast.
- Page 4 Valet/Override Switch Operation The valet switch is used to override the security system in the event that the transmitters are lost or fail to operate and to put the security system in non-operational mode (valet) for vehicle servicing etc. Valet Switch in the ON Position Valet Switch in the OFF Position Override Operation: (Security System is Armed) 1.
- Page 5 Remote Panic Press and hold the PANIC button for more than 3 seconds and the security system will respond in the following manner: A. The horn/siren will begin sounding. B. The parking lights will begin flashing. To turn off the panic alarm, press and release the ARM/DIS or PANIC button on the transmitter. The horn/siren will stop sounding and the parking lights will stop flashing.
- Page 6 Four horn/siren chirps = Tamper warning + security system is disarmed. Upgrade Options Available From Your Dealer (At An Additional Cost) The PL61 security system offers 7 upgrade options. Option #1: Remote Power Door Lock/Unlock Control Note: Your vehicle must have an electronic door locking system for this feature to operate.
-
Page 7: Programmable Features
Upgrade Options Available From Your Dealer (At an Additional Cost) (Continued) Option #5: Dual Zone Shock Sensor Installing option #5 will increase the level of security provided by your security system. Zone #1 of the dual zone shock sensor will detect lighter non-threatening disturbances that would normally set off most sensors and trigger the security system. -
Page 8: Limited Lifetime Warranty
CR2032. Limited Lifetime Warranty Magnadyne Corporation or its authorized agents will, for the life of the vehicle and to the original purchaser, repair, replace or refund the retail sales price of said product or any part thereof, at the option of the Magnadyne Corporation or its authorized agents, if said product or part is found defective in materials or workmanship, when properly connected and operating on the correct power requirements designated for the specific product.