Non-Hot Swap Device Indicators - HP NetServer LC 2000r Installation Manual

Chapter 2

Non-Hot Swap Device Indicators

The indicators for non-Hot Swap devices, which provide operational status, are
also shown in Figure 2-3. The indicators shown in Figure 2-3 also apply to the
rack-mount model (LC 2000r). See Table 2-4 for Backup Tape drive LED Codes.
Table 2-4. Backup Tape Drive LED Codes
Left LED Right LED
Off Off
On Off
Flashing* Off
Pulsing** Off
Off On
Off Pulsing**
On Pulsing**
Flashing* Pulsing**
Pulsing** Pulsing**
* Flashing at 4 Hz rate
** Pulsing at 2 Hz rate
NOTE
For more information on the HP Tape Drive and its error
codes, refer to the documentation provided with the tape drive
or refer to Hewlett-Packard's web site, at:
http://www.hp.com
Refer to Chapter 4, "Installing Mass Storage Devices," for
installation information.
Controls, Ports and Indicators
Definition
No Power
Cartridge Loaded, but No activity
Cartridge Loaded and Active
Loading/Unloading/Ejecting/Power-On
Self Test Fail
No Cartridge, but Caution (cleaning required)
Cartridge Loaded, but Caution (cleaning required)
Cartridge Loaded, Drive Active, Caution (cleaning
required)
Cartridge Loading/Unloading, Caution (cleaning
required)
.
13