Setting The Hp Netserver's Boot Passwords - HP NetServer LC 2000r Installation Manual

Chapter 10
5. Type in the seconds and press Enter, then use the arrow keys to leave this
field.
6. Scroll to System Date field to enter the system date in the field.
The dates are entered in the "System Date" field in the same way as the
time is entered in the "System Time" field. This field also has three
separate sub-fields for month, day, and year enclosed in brackets
[xx/xx/xxxx].
7. Type in the month and press Enter to move to the day field.
8. Then type in the day and press Enter again to move to the year field.
9. Type in the year and press Enter, and then use the arrow keys to leave this
field.
10. Use the right-arrow or left-arrow key to select the Exit menu.
11. Choose Exit Saving Changes from the list of exit options, then press
Enter.
A dialog appears and asks you to confirm your decision.
12. Choose Yes and then press Enter.
Then the HP NetServer reboots.

Setting the HP NetServer's Boot Passwords

Use this topic to set a password to boot the HP NetServer. Further, you can have
a separate administrator password and a user password, but the user password is
limited in access once booted.
To configure the HP NetServer for passwords and require a password on boot-up,
refer to the following procedure.
1. If not already in the Setup Utility, boot or reboot the system and press F2
when prompted.
2. Use the right-arrow or left-arrow key to select Security from the menu bar.
As soon as it is selected, the selections for the Security menu appear as
shown below.
Power-On Password
Hardware Security
The arrowhead indicates there is a submenu to select from.
Configuring the HP NetServer
115