Related Manuals for PSB CBR III
Summary of Contents for PSB CBR III
- Page 1 Prizelawn ® COMMERCIAL BROADCAST SPREADER MODEL CBR MODEL CBR III SS OWNER’S MANUAL...
- Page 2 ASSEMBLY Remove the spreader and components from carton and LOCKWASHER place hopper up-side down on a padded surface as shown. Insert ends of leg into handle 1/4-20 X 2” Hex Bolt brace as shown and align holes. Attach brace and leg to 1/4-20 NUT frame using (4) 1/4-20 x 2”...
- Page 3 Handle Slide handle lever between 1/4 Dia. Lever handle brackets as shown and Clevis Pin secure with (1) 1/4 dia. clevis pin and 3/32” dia. cotter pin. Make sure lever pivots freely. Install handle grips onto upper handle. 3/32” Dia. Cotter Pin Handle Grip...
-
Page 4: Operation
OPERATION Check the product package for the rate USE SWATH setting, and recommended swath width. Loosen WIDTH ON PACKAGE OR rate control knob and slide rate plate to the ADJUST PER OPERATOR’S proper setting. The pattern is controlled by WALKING SPEED loosening the two knobs on the discharge chute and moving the chute closer or farther away from the impeller (setting A, B, or C). -
Page 5: Application Rate
HOW TO DETERMINE SPREADER SETTINGS AND SPREAD WIDTH Two major factors should be considered when determining correct spreader settings of any product: 1. The product application rate, or the amount of material applied per 1,000 square feet. 2. The effective pattern width, or the actual width in which material is applied. Label settings are a guide and can be affected by numerous factors. - Page 6 RATE SETTING CONVERSION The following provides approximate Prizelawn settings for those units listed. III SS ® Prizelawn ® B C D III SS Setting Prizelawn ® B C D l ss Setting Prizelawn ® — 2 — 2.5 — 3 3.5 — 4 —...
- Page 7 RATE SETTING OLD STYLE The following provides PrizeLAWN ® V W X CBR III Setting PrizeLAWN V W X BigFOOT ® Setting PrizeLAWN ® — 2 4 — 5 6 — 7 9 — 10 11 12 — 13 14 15 — 16 — 17 18 —...
-
Page 8: Maintenance
MAINTENANCE Never store unused material in spreader. Return unused product to its original container. Oil Bearing In Hopper Wash spreader thoroughly after each use and dry completely in sun or heated area. Grease axle bearings in frame. Oil the impeller shaft bearing in hopper, pivot points on the shut- off plate and the spring in the housing behind the rate plate. - Page 9 Impeller 14625 14625 Rate Plate* 14932 15191 Free Wheel 15033 15033 Rate Control Knob* 12704 12704 Agitator 14510 14510 Pointer* 12708 12708 Fastener Package 15035-1 15035-1 Spring Housing Assembly* 12702-2 12702-2 © 2003 PSB COMPANY *Parts included in hopper assembly...