Setup
LDAP Server Setting
LDAP server settings can be specified for the following.
Item
LDAP Server Name
Server Address
Search Base
Authentication Setting
Maximum number of search
Connection time out
SSL/TLS
Port Number
Initialize Setting
Check Connection
bizhub 362/282/222
Description
Enter the LDAP server name. Up to 16 characters can be en-
tered.
Enter the IP address or host name of the LDAP server. Up to 64
characters can be entered.
Specify the location on the LDAP server where searches are to
be started.
Up to 255 alphanumeric characters can be entered, excluding
^.
Specify the authentication settings.
General Settings: Select the LDAP authentication method.
Login name: Enter if "General Settings" is set to "Anonymous".
Up to 64 alphanumeric characters can be entered, excluding ^.
Password: Enter if "General Settings" is set to "Anonymous".
Up to 32 alphanumeric characters can be entered, excluding ^.
Domain Name: Enter if "General Settings" is set to "GSS-SPNE-
GO". Up to 64 alphanumeric characters can be entered, exclud-
ing ^.
Specify the maximum number of hits to be received in an LDAP
search between 5 and 100.
Specify a search timeout between 5 and 300 seconds.
Select whether to perform encryption of the send data using
SSL/TLS.
Enter a number between 1 and 65535 for the port used to com-
municate with the LDAP server.
Clears all of the settings that were entered. After the settings are
cleared, check the message, and then touch [Enter].
Check the connection to the LDAP server, using the entered
settings.
3
3-45