HP PAVILION G6 Maintenance And Service Manual page 48

Notebook pc

Hide thumbs Also See for PAVILION G6:

Table of Contents

To replace the hard drive bracket, remove the four Phillips 3.0×3.0 screws (1) that secure the

hard drive bracket to the hard drive.

Pull the bracket (2) straight up to remove it from the hard drive.

To replace the hard drive adapter, remove the Phillips panhead 2.0 x 2.0 screw (1), and then

disconnect the adapter from the system board at the outside edge (2).

Then lift the adapter out at a 45-degree angle (3).

Reverse this procedure to install the hard drive.

Chapter 4 Removal and replacement procedures

Table of Contents

Show Quick Links

Table of Contents