5.
Use the Mylar tabs to remove the primary hard drive from the computer.
6.
If it is necessary to replace the primary hard drive bracket, remove the four Phillips PM3.0×3.0
screws (1) that secure the bracket to the primary hard drive.
7.
Lift the primary hard drive bracket straight up (2) and remove the bracket from the hard drive.
8.
If it is necessary to replace the primary hard drive isolators, disconnect the isolators from the hard
drive bracket. The primary hard drive bracket and isolators are included in the Hard Drive
Hardware Kit, spare part number 603772-001.
Reverse this procedure to reassemble and install the primary hard drive.
Component replacement procedures
41