Directories; Files; Disk Maintenance; Program Updates - 360 Systems DigiCart ex E-3000 Owner's Manual

Disk Maintenance

Internal hard disk maintenance is limited to functions such as Format/Partition Disk, Rename, and
Update Directories, which are all covered under Utility Menu Features beginning on page 3.

Program Updates

From time to time, 360 Systems may release new versions of the DigiCart/EX operating system
program that can be installed by the user via either a memory card or a file on the Ethernet Audio
server. Memory card program updates must be ordered from 360 Systems because a specially
formatted card is required. A DCSYS.360 file for use from a Network Drive can be downloaded or
emailed; contact 360 Systems Customer Service Department for details.
To check the current version number, press the
not in a menu mode). The current version number will appear on the top line of the command line
display.
U P
PDATE THE ROGRAM FROM A
Move or copy the update file, named "DCSYS.360" to one of the exported DigiCart base directories
on a DigiCart/EX network server. A base directory is the directory that the server makes available to
DigiCarts, and which can be seen with the Mount Network Drive utility.
From DigiCart, make the drive containing the program file the current drive.
Be certain the DigiCart is in the idle state. Press and hold
concurrently.
You will be prompted to confirm, "Write system from disk?" Press
The update will take approximately 10 seconds. Upon completion, DigiCart should report, "Flash
Update Success".
Turn off the power switch, wait a moment, and then restart DigiCart/EX. The new program will now
be current.
U P
PDATE THE ROGRAM FROM A
After obtaining a specially formatted memory card with the operating system program from 360
Systems, insert it into the DigiCart/EX Card Reader.
Make Drive 0 (the Card Reader) the current drive.
Be certain the DigiCart is in the idle state. Press and hold
concurrently.
You will be prompted to confirm, "Write system from disk?" Press
The update will take approximately 10 seconds. Upon completion, DigiCart/EX should report,
"Flash Update Success".
Turn off the power switch, wait a moment, and then restart DigiCart/EX. The new program will now
be current.
60 • Maintenance
ENTER
N S
ETWORK ERVER
M C
EMORY ARD
button while DigiCart/EX is idle (stopped and
, then press
UTILITY
to continue.
ENTER
, then press
UTILITY
to continue.
ENTER
HOT KEY 1
HOT KEY 1