Performing Scan To Pc Operations; Flow Of Scan Operation - Konica Minolta C350 User Manual

Using the Scan Functions
8.9

Performing Scan to PC Operations

The Scan to PC operation is used to send the image data scanned on this
machine directly to a computer using FTP.
Note
An FTP server application must be installed on the computer in
advance.
8.9.1

Flow of Scan Operation

Procedure
1
Using PageScope Web Connection, perform one-touch key
registration or temporary key registration.
"Registering Destinations in Advance" on page 8-25
2
Set the FTP application.
"Setting the FTP Application" on page 8-54
3
Start up the FTP application on the computer.
4
Using this machine's control panel, specify the destination of the
scanned data.
"Setting the Destination" on page 8-54
5
Using this machine's control panel, set the scan mode and document
designation.
"Scan Mode Screen" on page 8-14 and "Original Setting Screen" on
page 8-16
6
Set the document, and then press the [Start] key on this machine's
control panel.
The document is scanned. The scanned data is sent to an application
that receives the data using FTP.
7
Check the scanned data on the recipient computer.
Memo
If the registration of the destination and the FTP application
configuration are already done, perform steps 3 through 7.
The transmission destination to the computer is the root folder
specified by the application. The destination cannot be specified from
this machine.
C350
8
8-53