Restoring Factory Settings In Setup Utility; Exiting Setup Utility; Updating The Bios - HP 630 Maintenance And Service Manual

Restoring factory settings in Setup Utility

NOTE: Restoring defaults will not change the hard drive mode.
To return all settings in Setup Utility to the values that were set at the factory, follow these steps:
1. Turn on or restart the computer, and then press
message is displayed at the bottom of the screen.
2. Press f10
3. Use the arrow keys to select Exit > Load Setup Defaults.
4. Follow the on-screen instructions.
5. To save your changes and exit, press f10, and then follow the on-screen instructions.
– or –
Use the arrow keys to select Exit > Exit Saving Changes, and then press enter.
Your changes go into effect when the computer restarts.
NOTE: Your password settings and security settings are not changed when you restore the factory
settings.

Exiting Setup Utility

To exit Setup Utility and save your changes from the current session:
If the Setup Utility menus are not visible, press
arrow keys to select Exit > Exit Saving Changes, and then press enter.
To exit Setup Utility without saving your changes from the current session:
If the Setup Utility menus are not visible, press
arrow keys to select Exit > Exit Discarding Changes, and then press enter.

Updating the BIOS

Updated versions of the BIOS may be available on the HP Web site.
Most BIOS updates on the HP Web site are packaged in compressed files called SoftPaqs.
Some download packages contain a file named Readme.txt, which contains information regarding
installing and troubleshooting the file.
to enter Setup Utility.
esc while the "Press the ESC key for Startup Menu"
esc to return to the menu display. Then use the
esc to return to the menu display. Then use the
Using Setup Utility
91