Maintenance; After Each Use; Every Week; Lubrication - Horizon Fitness T72 User Manual

y
I i ii
i I iii i
in
Cleanliness of your treadmill and its operation environment will keep maintenanceproblems and service calls to a
minimum. For this reason, werecommendthat the following preventive maintenance schedule be followed.
AFTER EACH USE(DALLY)
Clean and inspect, following these steps:
• Turnoff the treadmill with the on/off switch, then unplug the power cord at the waft outlet.
• Wipedown the running belt, deck, motor cover,and console casing with a damp cloth. Never use solvents, as
they can cause damage to the treadmill.
• Inspect the powercord. If the power cord is damaged, contact HorizonFitness.
• Make sure the power cord is not underneath the treadmill or in any other area whereit can becomepinched or
cut.
• Checkthe tension and alignment of the running belt. Make sure that the treadmifl belt will not damage anyother
componentson the treadmill by being misaligned.
EVERY WEEK
Clean underneath the treadmill, following these steps:
• Turnoff the treadmill with the on/off switch then unplug the power cord at the waft outlet.
• Fold the treadmill into the upright position making sure that the lock latch is secure.
• Move the treadmifl to a remote location.
• Wipe_rvacuumanydustpartic_es_r_ther_bjectsinatmayhaveaccumu_atedunderneaththetreadmi__.
• Return the treadmill to its previous position.
EVERY MONTH - IMPORTANT!
• Turnoff the treadmill with the on/off switch, then unplug the power cord at the wall outlet.
• Inspect aft assemb!vbolts of the machine forproper tightness.
• Turnoff the treadmill and wait 60 seconds.
• Removethe motor cover.Wait untilALL LEDlights turn off.
• Clean the motor and !owerboard area to eliminate anylint or dust particles that may have accumulated.Failure
to do so may result in premature failure of keyelectrical components.
• Vacuumand wipe down the belt with a damn cloth. Vacuumany black/white particles that may accumulate
around the unit. These particles may accumulate from normal treadmill use.
EVERY6MONTHS OR150MILES
It is necessary_olubricate your treadmill running deck every six months
or ]50 miles to maintain optimal performance of your treadmill. Oncethe
treadmill reaches ]50 miles, the console will orompt you to lubricate the
treadmill. Onlyuse lubricant provided by HorizonFitness!
..... ;AMIN
• TURN OFF THETREADMILL w ith the on/off switch, then unplug the
powercord at the waft outlet.
• Loosen both the rear roller bolts. (For best results, place two
removable marks on both sides of the frame and note roller
position). Once the belt is loosened, take the bottle of lubricant
and apply it to the entire top surface of the running deck. Tighten
both rear roller bolts (matching up the marks for proper position) to
original position. After you have applied inbricant, plug in the power
cord, insert the safety key,start the treadmill and walk on the belt
for two minutes to spread the lubricant.
• Lubricate the air shocks with Teflonbased spray.
• Once lubrication is complete, reset the console by pressing and
holding 'STOP' and Speed in' buttons for 5 seconds.
RUNNING B ELT
RUNNING D ECK
Pleasecontact HorizonFitness with questions about applying lubricant toyour treadmill