Recalibrating The Thermostat; Air Conditioning; Your Personal Program; The "Waiting" Indicator During - Honeywell MAGIC STAT MS3000 Owner's Manual

RECALIBRATING THE THERMOSTAT

Your thermostat should normally display the correct room
temperature. Intherare event ofaninmrred display, thethermo-
stat can berecalibrated as follows:
has been on for at least 2 hours.
Make sure the thermostat
Place an accurate room thermometer near the left side of the
thermostat. Be careful not to touch thermometer or breathe on it.
Open the left door of the thermostat.
•l Locate the temperature adjustment screw.
Use a flat blade screwdriver to turn the screw slightly clock-
wise
to increase, or counterclockwise ~ to decrease the
indicated emperature.
After each turn, allow the thermostat to stabilize about 30 seconds.
Continue this procedure until the thermostat has the same temperature reading as the room
thermometer.
THE "WAITING" INDICATOR DURING AIR CONDITIONING
To prevent possible damage to your compressor, and to maximize the efficiency of your air
conditioning system, no controls can be activated for approximately 6 minutes after the com-
pressor shuts off. If you try to override the temperature during this time, the display will show
WAITING until the 6 minutes pass.

YOUR PERSONAL PROGRAM

Use the table below to plan your schedule before you begin programming. If you are pro-
gramming a different schedule for each day of the week, fill out-a different table for each day.
a
Typical Activity
Wake up
Leave home
Arrive home
After dinner
Retire
Extra Nighttime
Set Point (see
page 13)
a
You may program between 2 and 6 typical activity times.
b
You may program up to 8 different heating/cooling temperature combinations over the duration
of a week.
29
30
Your Start Time Heating
31
TEMPERATURE ADJUSTMENT
SCREW
69-8026—2
b
Desired Temperature
Cooling
69-8026—2