Honeywell CHRONOTHERM T8600D Product Data page 9

T8600D, T8601D AND T8602D CHRONOTHERM
Installer Setup
Number (Press
Time
change)
Select
Not used 31 and 32
Minimum off time 33
for the
compressor
Temperature 34
range stops in
heating
Temperature 35
range stops in
cooling
Not used 36
Temperature 37
display
adjustment
a
Number 2 must be set to 1 to extend fan operation.
IMPORTANT
Review the settings to confirm that they match the
system. Press Run Program to exit the Installer
Setup. The thermostat has saved the Installer Setup
changes and initiated a reset in order to operate with
these new settings. Be sure to set the current day
and time immediately.
Setting Current Day and Time
1. Press Set Current Day/Time.
NOTE: On initial power up or after an extended power
loss, 1:00 pm flashes on the display until a key
is pressed.
Time Set Program
Set Current
Run Set Current
Wake Leave Return
Program Day/Time
Day/Time
Heat/Cool
Hold Temp Day System
Settings
Daylight
Copy
Time
®
Table 6. Thermostat Installer Setup Options (continued).
Factory-Setting
key to
Display Description
— —
5 5 minute minimum off
time for the
compressor
90 Highest setpoint
heating can be set to
45 Lowest setpoint
cooling can be set to
— —
0 No difference in
displayed temperature
and actual room
temperature
Set Day/Time
PM
Mon
Sleep
Fan
M10312
IV DELUXE PROGRAMMABLE THERMOSTATS
(Press
Display
— —
0 thru 4 Minimum number of minutes (0
thru 5) the compressor will be
off between calls for the
compressor
40 to 89 Temperature range (1°F
increments) heating setpoint
can be set to
46 to 99 Temperature range (1°F
increments) cooling setpoint
can be set to
— —
3 thru -3 1—Display adjusts to 1°F
2—Display adjusts to 2°F
3—Display adjusts to 3°F
-1—Display adjusts to 1°F lower
-2—Display adjusts to 2°F lower
-3—Display adjusts to 3°F lower
2. Press Day until the current day is displayed.
NOTE: Sun=Sunday, Mon=Monday, Tue=Tuesday,
Wed=Wednesday, Thu=Thursday, Fri=Friday,
Sat=Saturday.
Run Set Current
Program Day/Time
Day
Hold Temp Day
Daylight
Time
3. Press Time
displayed.
NOTE: Tapping the Set Current Day/Time will change
the time in one hour increments.
Time
Run Set Current
Program Day/Time
Hold Temp Day
Daylight
Time
9
Other Choices
or key to change)
Description
higher than actual room
temperature
higher than actual room
temperature
higher than actual room
temperature
than actual room temperature
than actual room temperature
than actual room temperature
Set Day/Time
PM
Time Set Program
Tue
Wake Leave Return Sleep
Heat/Cool
System Fan
Settings
Copy
or Time until the current time is
Set Day/Time
AM
Time Set Program
Tue
Wake Leave Return Sleep
Heat/Cool
System Fan
Settings
Copy
Actual
Setting
—
—
M10313
M10314
68-0164—1