1-6. PROCESS AFTER FIXING FLASH ERROR
When "FLASH error" (Self-diagnosis Code E : 91 : ** ) occurs, to prevent any abnormal situation caused by high voltage, setting of the
flash is changed automatically to disabling charge and flash setting.
After fixing, this setting needs to be deactivated. Flash error code can be initialized by the operations on the Setup screen.
Method for Initializing the Flash Error Code
Initialize
Initializes the setting to the default setting.
OK
Cancel
1 Select [OK] with v on the control button, then press z.
The message "Initialize all settings Ready?" appears.
2 Select [OK] with v, then press z.
The settings are reset to the default setting.
• Make sure that the power is not disconnected during resetting.
1-7. LCD TYPE CHECK
Model
DSC-S60
LCD type
TYPE C
The LCD type can be discriminated with the mounted parts on the SW-446 board, or the width of flexible harness of LCD panel.
Note: About SW-446 board and LCD panel, discriminate LCD type on the machine, and replace the same type.
Checking method:
1)
Refer to "SECTION 2 DISASSEMBLY" to remove the rear cabinet assy.
2)
Referring the following figures, each type is discriminated with the mounted parts on the SW-446 board, or the width of flexible cable
of LCD panel.
Rear View (when the rear cabinet assy is removed.)
LCD panel
Wide: TYPE S
Width of Flexible Harness of LCD Panel
DSC-S60/S80/S90/ST80
See the following procedure.
Cancels the resetting.
DSC-S80
TYPE C
Narrow:
TYPE C
DSC-S90
TYPE C or TYPE S
SW-446 Board (Side B)
CA
Mounted Parts
D004
D006
1-4E
DSC-ST80
TYPE C
CA
TYPE C
TYPE S
—
Mount
Mount
—