Generator Use - Honda EX1000 Owner's Manual

GENERATOR USE
Connections to a Building's Electrical System
Connections for standby power to a building's electrical system must be made
by a qualified electrician. The connection must isolate the generator power
from utility power, and must comply with all applicable laws and electrical
codes.
m Improper connections to a building's electrical system can
allow electrical current from the generator to backfeed into the utility
lines. Such backfeed may electrocute utility company workers or others
who contact the lines during a power outage. Consult the utility company
or a qualified electrician.
)] Improper Connections to a building's electrical system
can allow electrical current from the utility company to backfeed into the
generator. When utility power is restored, the generator may explode,
burn, or cause fires in the building's electrical system.
Ground System
Honda portable generators have a system ground that connects generator
frame components to the ground terminals in the AC output receptacles. The
system ground is not connected to the AC neutral wire. If the generator is
tested by a receptacle tester, it will not show the same ground circuit condition
as for a home receptacle.
Special Requirements
There may be Federal of State Occupational Safety and Health Administration
(OSHA) regulations, local codes, or ordinances that apply to the intended use
of the generator. Please consult a qualified electrician, electrical inspector, or
the local agency having jurisdiction.
l
In some areas, generators are required to be registered with local utility
companies.
l
If the generator is used at a construction site, there may be additional
regulations which must be observed.
15