Lubricating The Pivot Arms; Adjusting The Self-Propelled Drive; Servicing The Spark Plug - Exmark metro 21 Operator's Manual

Exmark mower operator's manual
Hide thumbs Also See for metro 21:
Table of Contents

Advertisement

7. Remove the fuel tank from the mower.
8. Close the fuel valve.
9. Pour a small amount of fuel in the fuel tank, move the fuel around in the tank, and
pour it out into an approved fuel container.
10. Install the fuel tank and fuel line.

4.10 Lubricating the Pivot Arms

Service Interval: Lubricate after every 50 operating hours or when the season ends.
1. Move the rear wheel cutting height levers to the center setting.
2. Wipe the grease fittings with a clean rag (Fig. 25).
3. Install a grease gun onto the fitting and gently apply 2 or 3 pumps of #2 multi-
purpose lithium base grease (Fig. 25).
NOTE: Excessive grease pressure may damage the seals.
4.11 Adjusting the Self-Propel Drive (Self-Propelled Units Only):
If the lawn mower does not self-propel or has a tendency to creep forward when the
control bar is released, adjust the wheel drive control knob on the rear of the gear box.
1. Close the door in the lawn mower housing and remove the grass bag.
2. If the lawn mower does not self propel, rotate the control knob clockwise 1/2 turn to
tighten the belt.
If the lawn mower creeps forward, rotate the knob 1/2 turn counterclockwise to
loosen the belt (Fig. 26).

4.12 Servicing the Spark Plug:

Service Interval: Check the spark plug after every 100 operating hours.
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug (Fig. 5 & 7).
3. Clean around the spark plug.
4. Remove the spark plug from the cylinder head.
NOTE: Replace a cracked, fouled, or dirty spark plug. Do not clean the electrodes
because grit entering the cylinder can damage the engine.
5. Set the gap on the plug to 0.030 in. (0.76 mm) (Fig 27)
G0225
Figure 25
G0224
Figure 26
- 30 -
Grease Fitting
Control Knob

Advertisement

Table of Contents
loading

Table of Contents