American Standard Retrospect Round Front Toilet none Installation Instructions

Wall Hung Bathroom Sink
*
NOTE: For installation of models using concealed or exposed arms, follow instruction
provided by arms manufacturer.
Introduction: Thank you for selecting our products...products which have been the benchmarks of fine quality for years. To help
insure that the installation process will proceed smoothly, please read these instructions carefully before you begin. Also, review
the recommended tools and materials list; carefully unpack and examine your new plumbing fixture.
!
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
NOTE: Pictures may not exactly define contour of china and components.
Recommended Tools & Materials
Putty Kinfe
Pipe Wrench
Level
Channel Lock Pliers
1
Provide suitable reinforcement behind
finished wall for lavatory hanger mounting
*
screws. Determine horizontal center line
location of support from the table listed in
Step 2. (Make sure support bottom
extends to lavatory back wall bottom.)
NOTE: If replacing an existing sink be
certain to shut off water supply before
removing old sink.
2
Determine the
desired rim height
(for example 32")
then select from the
Table at right the
height of the hanger
mounting bolts
centerline
EXAMPLE:
For Lucerne:
32"-1"=31"
For Ledgewood:
32"+2-7/8"=34-7/8"
© American Standard Inc. 2003

INSTALLATION INSTRUCTIONS

Adjustable Wrench
Plumbers' Putty or
Caulking
Drill
C/L of 2X8
Support
*
Finished
Floor
TABLE
Part # Model
0124 Comrade
0321 Declyn
0355/0356 Lucerne
0372/0373 Penlyn
4300 Ledgewood
4867/4869 Regalyn
5300 Ledgemere
A
RIM
HEIGHT
*
WASTE
FINISHED FLOOR
Tubing Cutter
Phillips Screwdriver
3
Hanger
Location
4
Distance "A"
- 2-1/2" (64mm)
- 2-3/4" (70mm)
- 1" (25mm)
- 1/8" (3mm)
+ 2-7/8" (73mm)
+ 2-3/4" (70mm)
+ 2-1/2" (64mm)
C/L OF HANGER
ANCHORING SLOTS
HANGER
HOLES FOR
ANCHOR
SCREWS
IN BACK
DRAPERY
SUPPLIES AS
REQUIRED
Basin Wrench
Tape
Measure
Hacksaw
Saber Saw
Regular Screwdriver
Position hanger according to Step 2,
making sure its center is aligned with
the waste hole centerline. Mark the
hanger screw locations through its
mounting holes.
Drill pilot holes in positioning screw
slots of hanger. (Note: Some models
are supplied with anchor screws, or
steel hangers for lavatory installations.
Other models are not provided with
mounting hardware which can be
purchased at local hardware outlets.
Lavator-ies with bottom anchor screw
holes should be secured with anchor
screws in addition to hangers.
MOUNTING SCREW
HOLES (4)
POSITIONING
SCREW SLOTS (2)
730427-100 Rev. B