Advertisement

Quick reference guide
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
RINSE AID INDICATOR
SALT INDICATOR
When lit (at the end of the
When lit (at the end of the
cycle), the rinse aid dispenser
cycle), the salt reservoir needs
needs to be refilled.
to be refilled.
PROGRAM
DELAYED
ANTIBACTERIAL
START
SELECTION
RINSE
BUTTONS
Push the
This function
Push button
button
activates an antibacterial
(repeatedly) to
of required
rinse at the end of the wash
program and
delay the start of
cycle, guaranteeing a further
indicator of
the program.
reduction of bacteria. Press
Adjustable from 1
this program
the button to activate or
lights up (see
to 24 hours. With
deactivate the function. This
"Table of
each press of the
function can be used with
programs" -
button, the
the programs indicated in
delayed start
next page).
the table of programs. The
indicator increases
dishwasher door must be
by one hour and
kept shut for the entire
after 24 restarts
duration of the program in
from 0. Then press
order to guarantee
the Start button.
reduction of bacteria. If the
The dishwasher
door is opened the
will start after the
indicator lamp starts
set time.
flashing.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min).
With "Delayed start" selected it indicates the time remaining until program start (h.00)
- below 1h (0:mim).
If "Fx Ey " messages appears on the display, see page 9 - chapter " What to do if...".
TABLET
3)
SETTING
Press to
select(the
indicator lights up)
or deselect
tablets. If not
selected then
powder is a
default detergent.
MULTI-
KEYBOARD
ZONE
LOCK
Allows you to
This option
choose the washing
allows you to lock the
zones. Press this button
buttons on the
(repeatedly) to select the
control panel.
wash zones:
Children will not be
able to accidentally
start the dishwasher
both racks
by pressing the
buttons on the
control panel when
only lower
this option is
rack
selected. If you want
only upper
to activate this option
hold down the
rack (including
button for 3 seconds.
Repeat the same
- indicator lits
operation to unlock
the panel.
DELAY INDICATOR
When lit, the time
selection and delay start
countdown.
POWER
START/
CLEAN
RESUME
MAX
BUTTON
Thanks to the
Push this button to
additional power jets
start the selected
this option provides a
program: the indicator
more intensive and
lights up and goes off at
powerful wash in the
the end of the
Lower Rack, in the
program. When the
specific area. This
door is opened during
option is
a washing cycle, the
recommended for
cycle is temporarily
washing pots and
paused: the Start
casseroles (see page
indicator blinks. To
7). Press this button
resume the cycle close
to activate Power
the door and push
Clean (the indicator
Start button again.
lights up).
ADP 7955 TOUCH
KEYBOARD LOCK
INDICATOR
When lit, it indicates that
keyboard lock is active.
CANCEL/OFF
BUTTON
Push this button
to switch off the
control panel.
If pressed when a
program is running it
cancels the program
ongoing draining water
for 1 minute (0:01 is
shown into the display).
If pressed when the
dishwasher is switched
off, it drains any
possible liquids from
dishwasher (1 minute
process).
5019 396 01991
GB -1-

Advertisement

Table of Contents
loading

Summary of Contents for Whirlpool ADP 7955 TOUCH

  • Page 1 If the The dishwasher Repeat the same lights up). door is opened the - indicator lits will start after the operation to unlock indicator lamp starts set time. the panel. flashing. ADP 7955 TOUCH 5019 396 01991 GB -1-...
  • Page 2 2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”. 3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.
  • Page 3 First time use How to set water hardness in order to always assure the best cleaning results Water hardness should be set - Press and hold together Eco Program and CANCEL/Off buttons for minimum 3 seconds. only before the first wash or if - The current water hardness setting will be visible on the display.
  • Page 4 Daily check Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulator Visual The rinse aid dosage can be adjusted to the detergent indicator used. The lower the setting, the less rinse aid is dispensed (factory setting: position 4).
  • Page 5 How to load the racks Cutlery rack Position 1 Position 2 A - Two trays to load cutlery Load cutlery with the handle into the pins. Knives or cutlery with bulky handle can be This positions is ideal to load both cutlery, loaded with the head into the pins.
  • Page 6 How to load the racks Upper rack In the upper rack you can load glasses, cups, bowls and, in the right Adjustable glass holder - B (provided in some models) side of the rack, you can load the dessert dishes. helps to load stemmed glasses.
  • Page 7 How to load the racks Lower rack In the lower rack plates and pots can be loaded. Vertical plate holders When the “Half load/Multizone” is selected the cutlery basket - F (E) can be folded down to create more space to load pots. (provided in some models) can be placed in the lower rack.
  • Page 8 Select program Overview of programs The max. possible number of programs is illustrated in the chapter “Chart”. The corresponding programs for your appliance can be found on the panel (page 1). Choose program according to the attached Table of programs (page 2). Duration of the program depends on the external conditions in the apartment, temperature and pressure etc.
  • Page 9: Troubleshooting

    What to do if... If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. How the faults are shown on the display: Function number “F”x - blinking Error number “E”y - blinking...
  • Page 10 What to do if... Crockery and cutlery... Possible causes... Solutions..are not perfectly clean/have - T oo little space between dishes (incorrect - Arrange crockery so that items do not touch each other. Concave items (e.g. food residues arrangement of the concave items in the rack). bowls, cups) must be arranged facing downwards in the rack.
  • Page 11 What to do if... Crockery and cutlery... Possible causes... Solutions..have discoloured plastic parts - Tomato/Carrot juice. - Tomato sauce, for example, can lead to discolouring of plastic parts. Powder detergent is recommended as it allows slightly higher doses to be used for improved whitening.
  • Page 12 Precautions and general recommendations 1. Packing - Before cleaning or carrying out maintenance, disconnect the mains plug and turn The packaging materials are 100% recyclable and marked with the recycling symbol off the water tap; also in the event of any malfunction. - Repairs and technical modifications must be carried out exclusively by a qualified technician.

Table of Contents