American Standard Ravenna Pedestal Sink 0268.100 Specification Sheet

RAVENNA™ PEDESTAL SINK
• Contemporary sleek design
• Made from vitreous china
• Rear overflow
• Faucet ledge with generous shelf area
• Supplied with mounting kit
• Optional integral mounted towel bar
(ordered separately, installed by customer)
• Shown with 2000.101 Ceramix single lever faucet
(not included)
❏ 0268.800 Faucet holes on 8" (203mm) centers
❏
0268.400 Faucet holes on 4" (102mm) centers
❏
0268.100 Center faucet hole only
Nominal Dimensions:
24-1/4" x 20" x 34"
(616 x 508 x 864mm)
Separate Components:
❏ 0268.008 Pedestal top-8" (203mm) centers
❏ 0268.004 Pedestal top-4" (102mm) centers
❏ 0268.001 Pedestal top-Center hole only
❏
0041.000 Pedestal only
Bowl sizes:
19-3/8" (492mm) wide
11-7/8 (302mm) front to back
6" (152mm) deep
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• ASME A112.19.2M for Vitreous China Fixtures
• CAN/CSA B45 Series
Recommended Component:
❏ Integral Towel Bar: 3520.000
(Specify 002 Chrome or 295 Satin Nickel)
To Be Specified:
❏ Color: ❏ White ❏ Bone ❏ Linen ❏ Black
❏ Faucet*:
❏ Faucet Finish:
❏ Supplies:
❏ 1-1/4" Trap:
* See faucet section for additional models available
© 2008 AS America Inc.
20-1/4 (514mm)
3-1/4
(83mm)
PEDESTAL
TO WALL
5-1/4 (133mm)
PEDESTAL ANCHORING
SCREW HOLES 5/16 (8mm) DIA.
OPTIONAL
TOWEL BAR
8
(203mm)
8 (203mm)
7
(178mm)
*
20-1/2
(521mm)
NOTES:
* DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND "P" TRAP ARE
SUGGESTED.
▼ PEDESTAL ANCHORING SCREWS NOT INCLUDED.
■ SUITABLE FOR REINFORCEMENT ONLY. ACTUAL DIMENSIONS MUST
BE TAKEN FROM FIXTURE.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
INSTALLATION INSTRUCTIONS SUPPLIED WITH LAVATORY.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.2.
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided pages.
J13
RAVENNA™
PEDESTAL SINK
VITREOUS CHINA
4
FINISHED WALL
(102mm)
8
(203mm)
20
(508mm)
24-1/2
(622mm)
9-3/8
(238mm)
REF.
3/4" (19mm) DIA.
HOLES FOR
ANCHOR BOLTS
SUPPLIES
AS REQ'D
1-1/4 O.D.
WASTE
*
(864mm)
23
(584 mm)
1-1/4 O.D.
TAILPIECE
FINISHED
FLOOR
6-1/2 (165mm)
DRAIN
CHASE
34
OPEN
TO
REF.
FLOOR
PEDESTAL
SIDE SECTION
Revised 2/08 Revised