ATTENTION: WARRANTY SERVICE PROCEDURES The Fender 215 PRO is covered by the standard FMIC 5 Year Electronic Limited Warranty as it applies to Speaker Enclosures. PCB Assemblies and Electronic Components are covered for 5 years. Speakers, Drivers, Cabinet Assemblies, and Cabinet Hardware are covered for 1 year.
Page 2
Fender® Musical Instruments Corporation. It is Corporation. not to be sold or assigned to another party and is disclosed solely for use by Fender Authorized • Parts marked with two asterisks ( Service Centers for purposes of product service ) indicate the and maintenance.
1600 Watts, Program Drivers: Two 15” (38.1 cm) Fender Special Design cast frame woofers with 3” (7.6 cm) voice coil and 105 0z. (2.98 kg) magnet (p/n 0075912000) One horn tweeter with 1” (2.5 cm) voice coil and 8 oz. (0.23 kg) magnet...
215 PRO (This is the model name for warranty claims) SERVICE NOTES Input Assembly removal is required for lamp re- 3. Use a small screwdriver or other tool to remove placement and is accomplished by following these the blown lamp, which is visible through a cut- steps: out in the circuit board.
+ * Access to this part or assembly is controlled. Please contact the FMIC Customer Service Department. ** Safety Requirement part. Replacement must match Safety Agency…–Value, if specified –Type, if specified –Approval Mark(s) if on part. shaded + ** Both a unique Fender® part and a Safety Requirement part as defined above.
+ * Access to this part or assembly is controlled. Please contact the FMIC Customer Service Department. ** Safety Requirement part. Replacement must match Safety Agency…–Value, if specified –Type, if specified –Approval Mark(s) if on part. shaded + ** Both a unique Fender® part and a Safety Requirement part as defined above.
Page 7
215 PRO (This is the model name for warranty claims) Schematics and Drawings Service Diagram (Schematic) ....Bassman 410 PRO Input Assembly ....FBA Bass Pro Speakers End Item Assembly ....215 PRO...