Advertisement

ERC1512
OWNER'S OPERATING MANUAL
ORIGINAL INSTRUCTIONS

Advertisement

Table of Contents
loading

Summary of Contents for Ryobi ERC1512

  • Page 1 ERC1512 OWNER’S OPERATING MANUAL ORIGINAL INSTRUCTIONS...
  • Page 2 Fig. 1 Fig. 2...
  • Page 3 Fig. 6 Fig. 8 Fig. 3 Fig. 4 Fig. 7 Fig. 9 Fig. 5...
  • Page 4 Fig. 10 Fig. 12 Fig. 11 Fig. 13...
  • Page 5 Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications.
  • Page 6: General Safety Rules

    English DESCRIPTION 2. ELECTRICAL SAFETY a. Avoid body contact with grounded surfaces 1. Grounding pin such pipes, radiators, ranges, 2. Ground fault outlet refrigerators. There is an increased risk of electric 3. Auto/off shock if your body is grounded. 4. Tank pressure gauge b.
  • Page 7: Special Safety Rules

    English jewelry, or long hair can be caught in moving parts. knob fully counterclockwise after shutting off Do not overreach. Keep proper footing and compressor. balance at all times. Proper footing and balance c. When servicing a tool, use only identical replacement parts.
  • Page 8: Electrical Connection

    English attached. produce arcs or sparks and, therefore, when 16. Do not operate this tool if it does not contain a located in a garage, it should be in a room or legible warning label. enclosure provided for the purpose, or should be 17.
  • Page 9: Specifications

    English proper outlet installed by a qualified electrician. Accessory storage The air station features a storage space for pneumatic accessories. WARNING Improper installation of the grounding plug could result in a Carry handle risk of electric shock. The wire with green-colored insulation The air station has a carry handle for easy transport.
  • Page 10: Operation

    English Side connect storage areas CAUTION The side connect storage areas can secure up to two Do not use in an environment that is dusty or otherwise pneumatic nailers. contaminated. Using the air station in this type of environment may cause damage to the unit. Tank pressure gauge The tank pressure gauge indicates the pressure of the air in the tank.
  • Page 11: Tool Storage

    English surface. WARNING TOOL STORAGE Never exceed the pressure rating of the tool as recommended by the manufacturer. When using See Figure 6 - 7. this air station as an inflation device, always follow Pneumatic accessories may be stored in the accessory the maximum inflation guidelines stated by the compartment.
  • Page 12: Draining The Tank

    English air station remove and clean valve, then reinstall. NOTE: Each tool is different. Refer to the instructions of the manufacturer before operating a tool in the seated WARNING position. Unplug the air station and release all air from the tank before servicing.
  • Page 13: Environmental Protection

    English WARNING ENVIRONMENTAL PROTECTION Always wear eye protection during maintenance. If Recycle raw materials instead of disposing operation is dusty, also wear a dust mask. of as waste. The machine, accessories and packaging should be sorted for environmental-friendly recycling. WARNING Always release all pressure, disconnect from power supply, and allow unit to cool to the touch before cleaning or making repairs on the air station.
  • Page 14 English Risk of bursting. Do not adjust regulator to result in output presure greater than marked maximum pressure of attachment or item being inflated. Never use at pressure greater than 9.31 bar (135 psi). To reduce the risk of electric shock, do not expose to rain.
  • Page 15 TECHTRONIC INDUSTRIES (AUSTRALIA) PTY. LTD. Level 1. 666 Doncaster Road, Doncaster, Victoria 3108 Australia. Tel: 61 3 9840 3226 Fax No.: 613 9840 6133...

Table of Contents