Sign in today to find solutions:

Forgot your password?

Don't have an account? Sign up

Hobart A200T ML-104568 User Manual

Hobart music mixer user manual.

 
A200 MIXERS
MODEL
A200
A200T
A200DT
A200FT
ML-104567
ML-104568
ML-104569
ML-104570
701 S. RIDGE AVENUE
TROY, OHIO 45374-0001
I
N
S
T
R
U
C
T
I
O
N
S
FORM 19354 Rev. A (6-98)

Summary of Contents

  • Page 1

    A200 MIXERS MODEL A200 ML-104567 A200T ML-104568 A200DT ML-104569 A200FT ML-104570 701 S. RIDGE AVENUE TROY, OHIO 45374-0001 FORM 19354 Rev. A (6-98)

  • Page 2

    MODEL A200 MIXER – 2 –...

  • Page 3

    Installation, Operation, and Care of A200 MIXERS SAVE THESE INSTRUCTIONS GENERAL The model A200 mixer is a 20 quart, bench-type mixer with a H.P. motor, and a #12 attachment hub. With the use of special agitators, a 12 quart bowl may be used on the A200 mixers. The floor model A200FT and the deluxe finish model A200DT are equipped with a timer.

  • Page 4

    WARNING: MOVING BEATER IN BOWL. KEEP HANDS, CLOTHING, AND UTENSILS OUT WHILE IN OPERATION, DO NOT USE WITHOUT INTERLOCKED GUARD. CONTROLS All models are furnished with an On-Off toggle switch which controls power to the mixer. The Bowl Guard must be in position or the mixer will not operate. Refer to page 6. If the Bowl Support is not all the way up, the mixer will not operate unless the On-Off switch is held in the up position.

  • Page 5

    ATTACHMENT HUB THUMB SCREW GEAR SHIFT WIRE CAGE AGITATOR ALIGNMENT To Raise the Bowl While Mixing To raise the bowl while the agitator is mixing the product (when required by recipe or when using the Bowl Scraper Attachment): Load ingredients. Close Wire Cage Assembly. Select Low speed. To begin mixing, hold the On-Off switch in the up position;...

  • Page 6

    Bowl Guard (Fig. 2) The Wire Cage Assembly on the Bowl Guard can be rotated out-of-the-way to add ingredients or access the bowl and agitator. To rotate the Wire Cage Assembly to the rear . . . Rotate the Wire Cage Assembly to the left until it is positioned underneath the Splash Guard. Note how the grooves on the nylon Retainers allow the Wire Cage to ride around the circular Ridge of the planetary Drip Cup.

  • Page 7

    CLEANING WARNING: UNPLUG MACHINE POWER CORD BEFORE BEGINNING ANY CLEANING PROCEDURE. The mixer should be thoroughly cleaned daily. Bowls and agitators should be removed from the mixer and cleaned in a sink. DO NOT use a hose to clean the mixer — it should be washed with a clean damp cloth. The apron (Fig.

  • Page 8

    SERVICE If service is needed on this equipment, contact your local Hobart Service Office. – 8 – FORM 19354 Rev. A (6-98) PRINTED IN U.S.A.

Comments to this Manuals

Symbols: 0

Latest comments:

×

Select the desired size and copy embed code

Copy your embed code and put on your site: