Page 1
TABLE SAW IS NOT INCLUDED WITH THIS KIT Your new Long Miter/Rip Fence kit has been engineered and manufactured to Ryobi's high standard for dependability, ease of operation, and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance.
TABLE OF CONTENTS Introduction..................................2 Rules For Safe Operation ..............................2 Symbols.................................... 3 Unpacking..................................4 Loose Parts ..................................4 Tools Needed..................................5 Assembly ..................................5-8 Parts Ordering / Service ..............................10 INTRODUCTION This Long Miter/Rip Fence kit has many features for making WARNING: the use of this product more pleasant and enjoyable.
SYMBOLS The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and the explanations with them, deserve your careful attention and understanding. The safety warnings do not by themselves eliminate any danger. The instructions or warnings they give are not substitutes for proper accident prevention measures.
UNPACKING Your new long miter/rip fence kit includes a 41 in. extension Remove the parts from the box. Make sure that all items rail, plus the necessary brackets, and connecting hardware listed in the loose parts list are included. required to assemble a long miter fence and attach it to the ...
TOOLS NEEDED You need an adjustable wrench and phillips screwdriver to assemble this accessory. ADJUSTABLE #2 PHILLIPS WRENCH SCREWDRIVER ASSEMBLY Slide the locator pin into the bottom channel of the long WARNING: miter fence rail. Note: The locator pin assembled to the miter fence The table saw should never be connected to a power supply provided with your BT3000/BT3100/BT3100-1 table saw when you are assembling parts.
ASSEMBLY ASSEMBLE THE SAW GAGES SQUARE MITER/RIP FENCE RAIL See Figure 3. HEAD BOLT (1/2 in.) (LONG MITER FENCE RAIL) Place a saw gage into each end of the long miter fence rail. 1/4 in. WASHER Correct orientation of the saw gage to the rail is important. Align the slot in the saw gage with the slot in the rail.
Page 7
ASSEMBLY MITER/RIP FENCE RAIL (LONG MITER FENCE RAIL) ADJUSTING KNOB MITER FENCE HOLDER RIGHT POSITIVE SLIDING STOP BRACKET MITER TABLE SUPPORT BRACKET LEFT POSITIVE STOP BRACKET SLOT 5/16 in. WASHER SQUARE HEAD BOLT (1/2 in.) HEX BOLT (7/8 in.) WORK SUPPORT BRACKET KNOB NUT 1/4 in.
Page 8
9. Recheck all necessary steps. Recheck all bolts and screws for tightness. LONG RIP FENCE ASSEMBLY SHOWN ATTACHED TO A T-NUTS RYOBI TABLE SAW MITER/RIP FENCE RAIL (LONG RIP FENCE RAIL) SAW GAGE Fig. 6 ...
Page 9
Now that you have purchased your Long Miter/Rip Fence Kit, should a need ever exist for repair parts or service, simply contact your nearest Ryobi Authorized Service Center. Be sure to provide all pertinent facts when you call or visit.
Ryobi Authorized Service Center.Be sure to provide all pertinent facts when you call or visit. Please call 1-800-525-2579 for your nearest Ryobi Authorized Service Center.You can also check our web site at www.ryobitools.com for a complete list of Authorized Service Centers.