ZyXEL Communications NWA5000-N User Manual

802.11a/g/n wireless lan managed access point and 802.11a/b/g/n dual-radio managed access point and 802.11a/b/g/n dual-radio outdoor managed access point

Advertisement

NWA Managed Access Point
Series
USER'S GUIDE
NWA5160N 802.11a/g/n Wire-
less LAN Managed Access Point
NWA5560-N 802.11 a/b/g/n Dual-
Radio Managed Access Point
NWA5550-N 802.11 a/b/g/n Dual-
Radio Outdoor Managed Access
Point
Version 1.00
Edition 1, 07/2011
www.zyxel.com
Copyright 2011
ZyXEL Communications Corporation

Advertisement

Table of Contents
loading

Summary of Contents for ZyXEL Communications NWA5000-N

  • Page 1 NWA Managed Access Point Series USER’S GUIDE NWA5160N 802.11a/g/n Wire- less LAN Managed Access Point NWA5560-N 802.11 a/b/g/n Dual- Radio Managed Access Point NWA5550-N 802.11 a/b/g/n Dual- Radio Outdoor Managed Access Point Version 1.00 Edition 1, 07/2011 Copyright 2011 ZyXEL Communications Corporation www.zyxel.com...
  • Page 2 Indoor Models NWA5160N NWA5560-N Outdoor Model NWA5550-N...
  • Page 3 NWA Managed Access Point User’s Guide Indoor Models Device Panels KENSINGTON RESET CONSOLE ETHERNET POWER LOCK PORT PORT JACK POWER / SYS WLAN OR WLAN 1/2 ETHERNET...
  • Page 4: Hardware Connections

    NWA Managed Access Point User’s Guide LEDs. Color STATE DESCRIPTION Power / Green The NWA is powered on. The NWA is powered off. The NWA has succesfully booted. Flashing The NWA has encountered a system failure and cannot boot. Ethernet Green Flashing / The NWA has an active 10M/100M connection.
  • Page 5 NWA Managed Access Point User’s Guide With PoE 1. Connect the NWA to a PoE device with an 8-pin CAT5e cable. 2. Connect the PoE device to an upstream switch or directly to the NXC- 5200 Wireless LAN Controller.
  • Page 6: Console Port Configuration

    NWA Managed Access Point User’s Guide Without PoE 1. Connect the NWA to to an upstream switch or directly to the NXC- 5200 Wireless LAN Controller. 2. Connect the NWA to an appropriate power outlet and turn on the power. Console Port Configuration The NWA is pre-configured, but you may use the console port to manually configure the NWA if necessary.
  • Page 7 NWA Managed Access Point User’s Guide • 8 data bits, no parity, 1 stop bit • No flow control. Log in using ‘admin’ and ‘1234’ as the username and password. Welcome to NWA5560-N Username: admin Password: NWA IP Address The NWA is pre-configured to get a dynamic IP address from a DHCP server by default.
  • Page 8 NWA Managed Access Point User’s Guide Manually enter the IP address of the NXC on the NWA. You can enter up to two IP addresses for the NXC. Enter configuration mode Router# configure terminal Router(config)# capwap ap ac-ip These are the NXC IP addresses 192.168.1.1 192.168.1.2 Router(config)# show capwap ap Confirm that static discovery is used to find the...
  • Page 9: Wall Mounting Instructions

    NWA Managed Access Point User’s Guide For example: Router# configure terminal Router(config)# capwap ap vlan vlan-id 2 tag To see detailed NWA – NXC connection status, use the following command: Router# show capwap ap info SM-State RUN(8) msg-buf-usage 0/10 (Usage/Max) capwap-version 10118 Radio Number...
  • Page 10 NWA Managed Access Point User’s Guide 2. Drill two pilot holes for the screws. Make sure the distance between the centers of the holes and the size of screws match the specifications below. Be careful to avoid damaging pipes or cables located inside the wall when drilling holes for the screws.
  • Page 11 NWA Managed Access Point User’s Guide 5. Align the holes on the back of the NWA with the screws on the wall. Hang the NWA on the screws. You can also use the optional Ceiling Mounting Kit (sold separately) to mount the NWA on a ceiling instead of a wall.
  • Page 12: Outdoor Model

    NWA Managed Access Point User’s Guide Outdoor Model Device Panel WLAN2 WLAN1 WLAN1 WLAN2 RJ-45 Ethernet Cable Connection...
  • Page 13 NWA Managed Access Point User’s Guide Waterproofing Kit. 1. Put one end of the cable through the nut (C). 2. Open the claw (B) then close it tightly around the cable.
  • Page 14 NWA Managed Access Point User’s Guide 3. Put the body (A) over the cable then connect the end of the cable to the NWA. 4. Gently twist the body (A) into the NWA. 5. Tightly secure the cable connector, the body (A) and claw (B) with the nut (C).
  • Page 15 NWA Managed Access Point User’s Guide 6. Apply the water-proofing tape properly for enhanced protection. 7. Connect the other end of the Ethernet cable to the PoE Adaptor.
  • Page 16: Pole Mounting

    NWA Managed Access Point User’s Guide Pole Mounting Pole Mounting Kit M6 Nuts Pole Bracket U Bolt Install the NWA vertically with a +15, 0, or -15 degree angle relative to the pole.. Down Down 1. For +15 and 0 angle installations, position the bracket with the +15 mark on the top.
  • Page 17 NWA Managed Access Point User’s Guide For -15 installation, position the bracket so the -15 mark is on top. 2. This is a 0 angle installation example. Use a wrench to tighten the nuts onto the U bolt. 3. Use a wrench to tighten the four nuts onto the screws.
  • Page 18: Wall Mounting

    NWA Managed Access Point User’s Guide Wall Mounting Wall Mounting Kit Anchors M6 Screws M6 Nuts Bracket 1. Place the bracket where you want it on the wall (W) and mark the position of the outer holes with a pencil. Remove the bracket and drill the holes where marked.
  • Page 19: Safety Warnings

    NWA Managed Access Point User’s Guide 2. Use the nuts and a wrench to attach the NWA to the bracket. Legal Open Source Announcements This product uses Open Source software. To view the Open Source licenses associated with this product, see the Open Source Announcements appendix in the NXC5200 User’s Guide.
  • Page 20: Federal Communication Commission Interference Statement

    NWA Managed Access Point User’s Guide • Do NOT obstruct the device ventilation slots, as insufficient airflow may harm your device. • If you wall mount your device, make sure that no electrical lines, gas or water pipes will be damaged. •...
  • Page 21 NWA Managed Access Point User’s Guide End Product Labeling This transmitter module is authorized only for use in devices where the antenna may be installed such that 20 cm may be maintained between the antenna and users (for example access points, routers, wireless ASDL modems, and similar equipment).
  • Page 22 ZyXEL shall in no event be held liable for indirect or consequential damages of any kind to the purchaser.
  • Page 23: Regulatory Information

    Hereby, ZyXEL declares that this equipment is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. [Spanish] Por medio de la presente ZyXEL declara que el equipo cumple con los requisitos esenciales y cualesquiera otras disposiciones aplicables o exigibles de la Directiva 1999/5/CE. [Greek] ΜΕ...
  • Page 24 съществените изисквания и другите приложими разпоредбите на Директива 1999/5/ ЕC. [Icelandic] Hér með lýsir, ZyXEL því yfir að þessi búnaður er í samræmi við grunnkröfur og önnur viðeigandi ákvæði tilskipunar 1999/5/EC. [Norwegian] Erklærer herved ZyXEL at dette utstyret er I samsvar med de grunnleggende kravene og andre relevante bestemmelser I direktiv 1999/5/EF.
  • Page 25 The requirements for any country may evolve. ZyXEL recommends that you check with the local authorities for the latest status of their national regulations for both the 2,4- and 5-GHz wireless LANs.
  • Page 26 NWA Managed Access Point User’s Guide Location Frequency Range(GHz) Power (EIRP) Indoor (No restrictions) 2.4 – 2.4835 100mW (20dBm) 2.4 – 2.454 100mW (20dBm) Outdoor 2.454 – 2.4835 10mW (10dBm) Italy This product meets the National Radio Interface and the requirements specified in the National Frequency Allocation Table for Italy.

This manual is also suitable for:

Nwa5560-nNwa5550-nNwa5160n

Table of Contents