Advertisement
Quick Links
There are two ways to set up the
Gateway, run the Setup CD-ROM
or use this Quick Installation.
Linksys strongly recommends
that you run the Setup CD-ROM.
Run the Setup CD-ROM
Insert the Setup
CD-ROM into the
CD-ROM drive, and
follow the on-screen
instructions.
Use this Quick
Installation
Follow the instructions
in this Quick Installation.
This method should only
be used if you cannot
run the Setup CD-ROM.
QUICK INSTALLATION
ADSL Gateway
Advertisement
Related Manuals for Cisco ADSL Gateway
Summary of Contents for Cisco ADSL Gateway
- Page 1 QUICK INSTALLATION ADSL Gateway There are two ways to set up the Gateway, run the Setup CD-ROM or use this Quick Installation. Linksys strongly recommends that you run the Setup CD-ROM. Run the Setup CD-ROM Insert the Setup CD-ROM into the...
- Page 2 Connection 1� Make sure that all the devices that you are working with are powered down, including your computer(s) and the Gateway. Connect one end of the provided phone cable to the wall jack with ADSL service. Connect the other end of the phone cable to the DSL/Line port on the back of the Gateway.
- Page 3 Connect the power adapter to the Gateway’s power port and the electrical outlet. Connect the Power Adapter Connect the Power Adapter Power on the Gateway. Power on the computer that you want to use to configure the Gateway. NOTE: If you have more than one phone and you experience static on the line after installing the Gateway, then you will need an additional microfilter for each phone or fax that you use.
- Page 4 The Basic Setup screen appears. Refer to the settings provided by your ISP. Select the Encapsulation method your ISP has specified. For the Multiplexing setting, select LLC or VC. For the Virtual Circuit, enter the VPI and VCI settings. Proceed to the appropriate instructions for your Encapsulation method. NOTE FOR UK RESIDENTS ONLY: Select or enter the following settings unless otherwise instructed by your ISP.
- Page 5 RFC 1483 Routed or IPoA Enter the IP Address, Subnet Mask, and Default Gateway IP address. In the Primary and/or Secondary DNS fields, enter at least one DNS IP address. Click Save Settings. RFC 1483 Routed RFC 1483 Routed IPoA IPoA RFC 1483 Bridged - Dynamic IP Address For the IP Setting, select Obtain an...
-
Page 6: Bridge Mode Only
Linksys is a registered trademark or trademark of Cisco Systems, Inc. and/or its affiliates in the U.S.. and certain other countries. Copyright © 2007 Cisco Systems, Inc. All rights reserved. Other brands and product names are trademarks or registered trademarks of their respective holders.