American Standard Madera 16-1/8" Height Elongated Flush Valve Toilet 2305.100 Specification Sheet

BARRIER FREE
MADERA™ 16-1/8" HEIGHT 10" ROUGH TOILET
• Vitreous china
• Low-consumption (6.0 Lpf/1.6 gpf)
• Elongated bowl
• Fully glazed 2" ballpass trapway
• 10" x 12" water surface area
• Direct-fed siphon jet action
• 10" Rough-in
• 1-1/2" inlet spud
• 2 bolt caps
• 100% factory flush tested
2305.100 Top spud
2305.156 Top spud with slotted rim for
bedpan holding
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• ASME A112.19.2M (and 19.6M) for Vitreous
China Fixtures - includes Flush Performance,
Ball Pass Diameter, Trap Seal Depth and
all Dimensions
Nominal Dimensions: 778 x 381 x 409mm
(30-1/2" x 15" x 16-1/8")
Fixture only, seat and flush valve by others.
Recommended working pressure--between
25 psi at valve when flushing and 80 psi static
To Be Specified
Color: White Bone
Seat: Olsonite #95 open front seat less cover
Seat: Church #9500C open front seat less cover
Flush Valve: Sloan Royal #111 or equal
© 2003 American Standard Inc.
ELONGATED FLUSH VALVE TOILET
Silver Shell Black
CI-6
MADERA™16-1/8" HEIGHT
FINISHED WALL
775mm
(30-1/2)
102mm
470mm
(4)
(18-1/2)
C/L OF SEAT POST HOLES
38mm
( 5 - 1/2 CENTERS)
(1-1/2)
356mm
(14)
127mm
(5
13mm
(1/2)
254mm
(10)
C/L OF OUTLET
NOTES:
TO COMPLY WITH AREA CODE GOVERNING THE HEIGHT OF VACUUM BREAKER ON THE
FLUSH VALVE, THE PLUMBER MUST VERIFY DIMENSIONS SHOWN FOR SUPPLY ROUGH-
ING.
THIS TOILET DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 254MM (10") FROM
FINISHED WALL TO C/L OF OUTLET.
FLUSH VALVE NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerance
established by ANSI Standard A112.19.2
These measurements are subject to change or cancellation. No responsibility is assumed for use
of superseded or voided pages.
When installed so top of seat is 432 to 483mm (17" to 19") from the
finished floor.
MEETS THE AMERICAN DISABILITIES ACT GUIDELINES AND ANSI A117.1
REQUIREMENTS FOR ACCESSIBLE AND USEABLE BUILDING FACILITIES-
CHECK LOCAL CODES.
VITREOUS CHINA
1" N.P.T. OR 1" C.W.T. SUPPLY
TO FLUSH VALVE
121mm
(4-3/4) 702mm
(27-5/8)
394mm
(15-1/2)
1 - 1/2
SPUD
410mm
(16-1/8)
FINISHED FLOOR
235mm
(9-1/4)
Revised 5/03