Interfacegroup; Ipsectunnel - D-Link NetDefend DFL-210 Cli Reference Manual

3.30.4. InterfaceGroup

Network
RemoteEndpoint
EncapsulationChecksum
OriginatorIPType
OriginatorIP
Metric
AutoInterfaceNetworkRoute
OuterPBRTable
UseSessionKey
SessionKey
MemberOfRoutingTable
RoutingTable
Comments
3.30.4. InterfaceGroup
Description
Use an interface group to combine several interfaces for a simplified security policy.
Properties
Name
Equivalent
Members
Comments

3.30.5. IPsecTunnel

Description
An IPsec tunnel item is used to define IPsec endpoint and will appear as a logical interface in the
Specifies the network address of the GRE interface.
Specifies the IP address of the remote endpoint.
Add an extra level of checksum above the one provided by
the IPv4 layer. (Default: No)
Specifies what IP address to use as source IP in e.g. NAT.
(Default: LocalInterface)
Manually specified originator IP address to use as source IP
in e.g. NAT.
Specifies the metric for the auto-created route. (Default: 90)
Automatically add a route for this interface using the given
remote network. (Default: Yes)
The outer PBR Table to use. (Default: main)
Specify whether or not to use a session key. (Default: No)
Session key. (Default: 0)
All or Specific. (Default: All)
Specifies the PBR table to insert the interface IP route into. It
also means that the specified routing table will be used for all
routing lookups, unless overridden by a PBR rule. (Default:
main)
Text describing the current object. (Optional)
Specifies a symbolic name for the interface. (Identifier)
Specifies if the interfaces should be considered security equivalent, that means
that if enabled the interface group can be used as a destination interface in rules
where connections might need to be moved between the two interfaces. (Default:
No)
Specifies the interfaces that are included in the interface group.
Text describing the current object. (Optional)
136
Chapter 3. Configuration Reference