Code Settings; Operation - Heath Zenith SL-6166 Owner's Manual

Operation

Press the doorbell button to verify that the
Push
doorbell and chime work properly. If the chime
Button
does not sound see the Troubleshooting guide
on page 4.
4.
Mount the doorbell button.
Use either screws or double sided tape to mount
Doorbell Button
the doorbell button.
To mount with screws, remove the back of the case by pushing in the tab on
the bottom with a small screwdriver and rotating the blade.
Attach the back of the case to the door jamb or wall. Snap the front of the
button back on.
When attaching the doorbell button using the double sided tape, make sure the
surface of the door jamb or wall is clean.
Code and Tune Settings

Code Settings

Note: Most installations will not require you to change any of the jumpers
on your doorbell.
WARNING: Disconnect chime unit from power source before opening
code access door. Close door and replace screw before reconnecting
to power.
The doorbell button and chime communicate by using a code that can be
changed by removing and/or adding jumpers on both the doorbell button and
chime. The code is factory set; however, there are 128 selectable codes that
allow you to expand your system and prevent outside interference. Another
wireless doorbell system or other wireless products may cause interference
and the system may not function properly. Follow the instructions below for
setting a new code.
1. Disconnect the power to the doorbell button and chime.
-2- 595-5494-11