Troubleshooting Guide - Heath Zenith SL-5411 Manual

SYMPTOM POSSIBLE CAUSE
Lights will not come 1. Light switch is turned off.
on. 2. Flood
3. Fuse is blown or circuit breaker is
4. Daylight turn-off is in effect (re-
5. Incorrect circuit wiring, if this is a
6. Re-aim the sensor to cover de-
Lights come on 1. Light Control may be installed in
in daylight.
2. Light Control is in Test.
Lights come on for 1. Light Control may be sensing
no apparent rea-
son.
2. Range
See your Canadian Tire retailer for warranty information.

TROUBLESHOOTING GUIDE

If you experience a problem, follow this guide.
light is loose
burned out.
turned off.
check after dark) .
new installation.
sired area.
a relatively dark location.
(Set control switch to an
ON-TIME position) .
small animals or automobile traf-
fic (re-aim sensor) .
is set too
(Reduce Range) .
SYMPTOM
Lights stay on
or continuously.
Lights flash on
and off.
high.
4
POSSIBLE CAUSE
1. A flood lamp is positioned too close to
the sensor or pointed at nearby ob-
jects that cause heat to trigger the
sensor. (Reposition the lamp away
from the sensor or nearby objects) .
2. Light Control is pointed toward a heat
source like an air vent, dryer vent, or
brightly-painted heat-reflective sur-
face. (Reposition sensor) .
3. Light Control is in Manual Mode.
(Switch to Auto.)
1. Heat or light from the lamps may be
turning the Light Control on and off.
(Reposition the lamps away from the
sensor) .
2. Heat being reflected from other ob-
jects may be affecting the sensor.
(Reposition sensor) .
3. Light Control is in the Test mode and
warming up. (Flashing is normal un-
der these conditions) .
4. Light may be leaking through the
floodlamp reflectors. (Replace the lamps
with new high quality PAR 38 lamps) .
595-5766-03