Conference; Call Park - System - NEC Univerge SV8100 User Manual

CONFERENCE

1. Establish an intercom or trunk call.
2. Press the Conf Softkey or the Conference key
(Service Code 751:07).
3. Dial the extension you want to add.
-OR-
Access an outside call.
To get the outside call, you can either press a
Note:
Line key or dial a trunk/trunk group access
code.
4. When the called party answers, press the
Conference key twice.
If you cannot add additional parties to your
Note:
conference, you have exceeded the system's
Conference limit.
5. Repeat steps 2~4 above to add more parties.
2-11 MON 10:56AM
TALKING TO
Conf
ICM DIAL
AnHd Dir
STA 12345
CONF
CALL PARK – SYSTEM
To Park a call in a system orbit:
You can Park intercom or trunk calls.
Note:
1. Press the Park key (Service Code 752: *04 + orbit).
The Park key LED lights.
Note:
2. Use Paging to announce the call.
3. Press the Speaker key to hang up.
If not picked up, the call will recall you.
Note:
-OR-
1. Press the Transfer key.
2. Dial #6 and the Park orbit (01~64).
If you hear a busy tone, the orbit is busy. Try
Note:
another orbit.
3. Use Paging to announce the call.
4. Press the Speaker key to hang up.
If not picked up, the call will recall you.
Note:
PARK HOLD
29
Park No. Dial