Tiger Electronics Hitclips Micro Music Watch 59947 Instruction

Micro Music Watch
Micro Music Watch
Instruction
Instruction
We hope you enjoy your new
HitClips watch - it's a functioning
timepiece as well as a portable
micro music mix music player!
Just put it on and you're good to go!
Includes:
Watch
Earbud headset
HitClips Micro Music Clip
3
5
1. Mode and Set buttons
(bottom and top buttons near clock)
2. Play/stop button
3. Volume control switch
4. Eject button
5. Headphone (plug-in)
Watch functions
Watch functions
There are two buttons by the clock
display, the MODE button (top) and the
SET button (bottom). You may need to
use a fine point to press the buttons,
such as a ball-point pen.
To set the date:
Press the Set button (bottom) twice. You should now
see a number that represents the month. Press the
Mode button to cycle the months to the correct one.
When you have reached the right number, press the
Set button to move to the day. Press the Mode button
to cycle through until you reach the correct day. Press
the Set button to confirm your choice.
To set the time:
After setting the month and day, the display will
automatically change, allowing you to set the hour
(1 2-hour cycle, including a.m. and p.m.). Press the Mode
button to cycle through the hours to the correct one.
Press the Set button to move to minutes. Cycle through
the minutes by pressing the Mode button. When the
minutes are correct press the Set button to confirm.
Now the time and date are set!
If you want to check the date, press the Mode button.
Press it again to check the seconds, and one more time
to return to the clock.
NOTE: Once the time and date are set, the LCD display
Ages 5 & Up
Item No. 59947
To play a HitClips Micro Music Clip:
Carefully insert the HitClips chip into the slot. Plug the
earbud jack into the proper hole. Play and stop by
pressing the Play/Stop button. Adjust the volume by
using the Volume Control switch (low and high).
To eject a HitClips Micro Music Clip:
Press the Stop button to stop the music, then press the
Eject button and carefully remove the HitClips Micro
Music Clip.

Battery Installation

Battery Installation
2
4
1
1. Unscrew battery door. (see diagram)
2. Remove used batteries and dispose of properly.
3. Insert 1 new CR2032 and 1 GP364 / SR60 batteries.
4. Replace batteries door and tighten screw.
To ensure proper function To ensure proper function
• Do not mix old and new batteries.
• Do not mix alkaline, standard, or rechargeable batteries.
• Battery installation should be done by an adult.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the
toy before being charged (if removable).
• Rechargeable batteries are only to be charged under
adult supervision (if removable)
• Only batteries of the same or equivalent type as
recommended are to be used.
• Batteries are to be inserted with correct polarity.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• Do not dispose of
batteries in fire,
batteries may explode
or leak.
will only show the time. You may still press the
Set button to cycle through and see the date if
you wish.
If you would like the time and date to alternate
one at a time on the LCD screen automatically,
simply press the Set button once. The date will
flash for 2 seconds and then the time will flash
for 2 seconds. This will continue until the Mode
or Set buttons are pressed again.