Behringer Filter Machine FM600 User Manual

FILTER MACHINE FM600
Ultimate Filter Modeling Effects Pedal
Thank you for showing your confidence in us by purchasing the BEHRINGER FILTER MACHINE FM600.
This Filter Modeler delivers the whole range from funky auto-wah, twin, band-pass to swirling low-pass
filter effects—at the touch of a footswitch. Discover the world of moving filters and take off with sounds
you have never heard before.
1. Controls
(6)
(2)
(1)
(9)
(1) The FILTER switch is used to select one of three filter types (BP=Band Pass, TF=Twin Filter
band pass, LP=Low Pass), which deliver completely different sounds. Cut-off and center
frequencies respond to the dynamics of your playing.
(2) The SENS knob determines the sensitivity of the filter and hence the level at which the filter
frequency modulation starts to work.
(3) The PEAK knob is used to define the shape of the filter from narrow to wide.
(4) The POL switch determines whether the filter frequency moves up to higher frequencies (UP)
or down to lower frequencies (DOWN) according to the dynamics of your playing.
(5) With the RANGE knob, you can alter the travel range of the filter frequency.
(6) The ON/BATT LED lights up, as soon as the effect is activated. Furthermore, you can check the
status of the battery.
(7) The footswitch is used for switching the effect on/off.
(8) The 1/4" TS connector (IN) connects to your instrument.
(9) The 1/4" TS connector (OUT) sends the signal to your amp/combo.
Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the
9 V battery (not included), press the hinges with a ballpen and remove the pedal cover. Be careful not
to scratch the unit.
(3)
(5)
(4)
(8)
(7)