Harman Kardon AVR80 Owner's Manual page 22

Audio/video receiver
Hide thumbs Also See for AVR80:
Table of Contents

Advertisement

AVR80 manual
11/01/98 13:01
Side 16
TV or Projection Screen
Left Front
Center Front
Right Front
Speaker
Speaker
Speaker
Optional Rear Wall Mounting
At least 15 cm from ceiling
At least 60 cm
System Configuration
16
Surround speakers should be placed on
the side walls of the room, at or slightly
behind the listening position. The center
of bidirectional speakers should face into
the room with the active speaker drivers
pointing towards the front and rear of the
room The speakers should be located so
that the bottom of the cabinet is at least
60 cm higher than the listeners’ ears
when in the desired area.
If side wall mounting is not practical, the
speakers may be placed on a rear wall,
behind the listening position. Again, they
should be located so that the bottom of
the cabinet is at least 60 cm higher than
the listeners’ ears. The speakers should be
no more than two meters behind the rear
of the seating area.
Subwoofers produce non-directional
sound, so they may be placed almost
anywhere in a room. Subwoofer
placement is highly influenced by room
size and shape, and the type of subwoofer
used. Follow the instructions of the
subwoofer’s manufacturer, or experiment
with the best location for a subwoofer in
your listening room.
Once the speakers have been placed in the
room and connected, the final step is to
enter the configuration information and
balance the speaker output levels. Before
proceeding further this is a good time to
review the installation section of the
manual to make certain that all
connections are properly made.
System Settings
1. Plug the unit into an AC wall outlet
and press the
button on either
Power
the front panel
or the remote
.
(
b
Note that the ring surrounding the front
panel switch will turn green, and the
front panel display will illuminate.
2. Check to see that the unit is configured
to the video broadcast standard in use in
your country by pressing and holding the
button on the front panel
for
!
OSD
more than three seconds. The front panel
display will indicate the current setting. If
the setting is not correct press the button
again until the correct standard (PAL,
SECAM or NTSC) is displayed.
3. Turn on the TV connected to the
receiver. Select the appropriate video
input on the TV.
NOTE: Although the unit will switch “S”
video signals, the on screen menus
control system is NOT visible on the S
video output.
4. Press any of the navigational arrow
buttons or the
button on
SELECT r
the remote to bring the
up
MAIN MENU
on your video screen.
(Figure #1)
5. Press the
button five times until
¤
the on screen
cursor is pointing to
>
.
SET U P MENU

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents