Table of Contents
Advertisement
Troubleshooting Guide
SYMPTOM
Unit does not function when Main
Power Switch is pushed
Display lights, but no sound
or picture
Unit turns on, but Front-Panel
Display does not light up
No sound from any speaker;
Light around power switch is red
No sound from surround or
center speakers
Unit does not respond to
remote commands
Intermittent buzzing in tuner
Letters flash in the Channel Indicator
Display and Digital Audio stops
HDCD encoded disc does not trigger
HDCD indicator
Processor Reset
In the rare case where the unit's operation or
the displays seem abnormal, the cause may
involve the erratic operation of the system's
memory or microprocessor.
To correct this problem, first unplug the unit
from the AC wall outlet and wait at least three
minutes. After the pause, reconnect the AC
power cord and check the unit's operation. If
the system still malfunctions, a system reset
may clear the problem.
To clear the AVR 7000's entire system memory
including tuner presets, output level settings,
46 TROUBLESHOOTING GUIDE
CAUSE
• No AC Power
• Intermittent input connections
• Mute is on
• Volume control is down
• Display brightness is turned off
• Amplifier is in protection mode
due to possible short
• Amplifier is in protection mode
due to internal problems
• Incorrect surround mode
• Input is monaural
• Incorrect configuration
• Stereo or Mono program material
• Weak batteries in remote
• Wrong device selected
• Remote sensor is obscured
• Local interference
• Digital audio feed paused
• Surround mode in use
• Analog feed in use
delay times and speaker configuration data,
first put the unit in Standby by pressing the
System Power Control button 2. Next,
press and hold the Tone Mode 6 and the
FM Mode Selector @ buttons for three
seconds.
The unit will turn on automatically and display
the RESET message in the Main
Information Display W. Note that once you
have cleared the memory in this manner, it is
necessary to re-establish all system configuration
settings and tuner presets.
NOTE: Resetting the processor will erase any
configuration settings you have made for
SOLUTION
• Make certain AC power cord is plugged into
a live outlet
• Check to see if outlet is switch-controlled
• Make certain that all input and speaker connections
are secure
• Press Mute button
• Turn up volume control
• Follow the instructions in the Display Brightness section
on page 31 so that the display is set to VFD FULL
• Check speaker wire connections for shorts at receiver and
speaker ends
• Contact your local Harman Kardon service depot
• Select a mode other than Stereo
• There is no surround information from mono sources
• Check speaker mode configuratioin
• The surround decoder may not create center or rear channel
information from nonencoded programs
• Change remote batteries
• Press the AVR selector
• Make certain front panel sensor is visible to remote
or connect remote sensor
• Move unit or antenna away from computers, fluorescent
lights, motors or other electrical appliances
• Resume play for DVD
• Check that Digital Input is selected
• Select "Surround Off" mode
• Connect and select digital connection to CD player
speakers, output levels, surround modes, digital
input assignments as well as the tuner presets.
After a reset the unit will be returned to the
factory presets, and all settings for these items
must be reentered.
If the system is still operating incorrectly, there
may have been an electronic discharge or
severe AC line interference that has corrupted
the memory or microprocessor.
If these steps do not solve the problem, consult
an authorized Harman Kardon service depot.
Hide quick links:
Advertisement
Table of Contents
