Harman Stove Company Accentra The Harman Accentra Pellet Insert Installation And Operating Manual page 8

Harman stoves the harman accentra pellet insert installation & operating manual
Table of Contents

Advertisement

Installation: Removing unit from skid
How to Reduce the Weight for Installation
1. Remove the top/lid assembly and side panels.
Note: Removal of the cast hopper lid itself is
NOT necessary or recommended.
Note: The hopper lid must be in the "OPEN" position
before the top/lid assembly can be lifted of f or
reinstalled on the stove body.
There are (4) 1/4-20 x 1/2" flange head bolts securing
the top/lid assembly to the stove body. They can be
removed from the underside with a 3/8" socket.
The cast top and lid assembly bolt down bars:
On each side of the stove body, underneath the cast
top, are (2) 1/4" flange head bolts.See Fig. 12.
These bolts pull the cast top and lid assembly down
onto the hopper gasket to seal the hopper.
They also allow for a small amount of front to back
adjustment for alignment of the top into the wing
pockets.
Protector Angles: These angles are designed to
protect the blower motor from damage when
placed on a flat surface. Be careful where and
Fig. 10
how the stove body is handled.
Mounting Shell
Be careful not to
damage
the
distribution blower
located under the
insert. There are
gua rds on bot h
sides of the motor
to allow the insert
to re st on a flat
surface, however,
extra care should
be taken.
Distribution Blower
(2) Spring Latches
(One on each side)
Fig. 11
Bolts require a
(View looking up under the cast top.)
Fig. 12
Remove the cast side panels by lifting them upward
off of the hinge pins. See Fig. 13.
Top and Lid Assembly
Medallion
Ash Pan
3/8" socket.
Top bolt down bar
Center
Exchanger
Cover
Internal
Cast Iron
Flame Guide
(4) pieces
9
Heat

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Accentra

Table of Contents